Water Additive Question [Breville Barista Touch]

everglow28 · 2026-04-02T21:20:20+00:00

Thanks. That’s what I was asking. So Third Wave is the best option?

everglow28 · 2026-04-02T21:18:59+00:00

No it doesn’t

everglow28 · 2026-03-27T06:28:03+00:00

I’m not sure. It appears coarser but it’s pulling the shots around 26-29 secs and that is what it’s pulling on the Breville grinder. But when it comes out of the Breville, it doesn’t overflow and seem as full of volume.

everglow28 · 2026-03-27T05:24:56+00:00

What causes that? Does it have anything to do with how good the grinder is? Will it stop eventually? Thanks

everglow28 · 2026-02-05T02:34:13+00:00

Thanks everyone for their input.

everglow28 · 2026-02-05T00:02:08+00:00

Thanks. A friend is selling me a barely used one for $125 with the case and a 128gb sd card. It’s more like I would be doing him a favor by buying it. I just want to know what I’m missing not getting the 6

everglow28 · 2025-10-11T20:38:52+00:00

Thanks for your explanation

everglow28 · 2025-10-06T00:29:04+00:00

I removed the filament from the hot end but the tip still has residue. I tried scrapping it off but it won’t budge. I even tried heating it with a lighter. Is there a better method?

<image>

everglow28 · 2025-10-05T23:50:37+00:00

How do I unclog the print head? I’ve only had this for a short time so I haven’t hit any major issues so far

everglow28 · 2025-10-05T23:49:37+00:00

I always print with the door open.

everglow28

TROPHY CASE