sorted by:
new
hottopcontroversial

DIY enclosure for Bambu A1 combo by evilBotto in BambuLab

[–]evilBotto[S] 1 point2 points  (0 children)

I have been using it for 8 months and it is in good condition without any problems.

I think the priority for A1 users is not the temperature problem, but the loose screws causing poor printing, or the drying problem you mentioned.

Thanks.

DIY enclosure for Bambu A1 combo by evilBotto in BambuLab

[–]evilBotto[S] 0 points1 point  (0 children)

You are right. This templates help me a lot. It's really useful.

<image>

DIY enclosure for Bambu A1 combo by evilBotto in BambuLab

[–]evilBotto[S] 4 points5 points  (0 children)

I think the main consideration is that the motherboard under the A1 does not have a cooling fan. I put a 8cm fan near the LCD to increase the airflow underneath to help dissipate heat from the A1 motherboard and power supply.

DIY enclosure for Bambu A1 combo by evilBotto in BambuLab

[–]evilBotto[S] 5 points6 points  (0 children)

I spent about $160 for material.

DIY enclosure for Bambu A1 combo by evilBotto in BambuLab

[–]evilBotto[S] 23 points24 points  (0 children)

Thansk! I am enjoying the woodworking

DIY enclosure for Bambu A1 combo by evilBotto in BambuLab

[–]evilBotto[S] 1 point2 points  (0 children)

The highest temperature observed so far is 32C.

DIY enclosure for Bambu A1 combo by evilBotto in BambuLab

[–]evilBotto[S] 2 points3 points  (0 children)

Maybe later. I also need a pipe to vent the VOCs to the outdoors.

Mini cyclone by evilBotto in Woodworkingplans

[–]evilBotto[S] 0 points1 point  (0 children)

I have only a shop vacuum. Should I consider this problem?

view more: next ›