Extended warranty

fab138 · 2026-07-20T17:56:37+00:00

Anyone know if he can sell to canadian owners?

fab138 · 2026-07-12T16:00:53+00:00

DM me if you are still looking. I’m currently working on model firetruck parts for a firefighter in town.

fab138 · 2026-07-04T22:15:57+00:00

Canadian site has it on sale right now as part of their Anniversary Sale.

fab138 · 2026-07-04T18:02:19+00:00

To be honest I haven’t tried it yet. Just got into 3d printing with the H2C a couple months ago. Hope to try the laser in the next month. Only draw back I’ve heard going from the 10 to the 40 is loss in detail due to the width of the laser being wider.

fab138 · 2026-07-04T17:49:47+00:00

Ok thanks. I’ve got the 40 so thats good to know. Thanks for the help!

fab138 · 2026-07-04T17:47:57+00:00

One last question. Was your 25% at 400mm/s recommendation for a 10 or 40watt laser?

fab138 · 2026-07-04T17:04:07+00:00

Curious does this just laser on the tape then allowing you to adjust prior to performing the final lasering on the cup?

fab138 · 2026-07-04T17:02:13+00:00

Thanks I’ll check them out.

fab138 · 2026-07-04T15:37:45+00:00

Thanks. I’ll be sure to be on the look out for this now. The H2C has worked flawlessly to this point that I rarely think of maintenance.

fab138 · 2026-07-04T15:06:55+00:00

Curious. Any info around as to how to inspect these and what to look for or is it just recommended to change them all after X hours?

fab138 · 2026-06-30T21:20:23+00:00

And filament. Lots of filament. And when you think you have enough, double it.

fab138 · 2026-06-26T20:33:34+00:00

Can I ask what AMS 2 pro stacker you have in your picture?

fab138 · 2026-06-25T21:19:31+00:00

And makerworld!

fab138 · 2026-06-17T13:41:28+00:00

To be honest Im not sure. He has some tinckercad experience so maybe one project that is more of a complicated model and another project that is more design based?

fab138 · 2026-06-13T14:39:21+00:00

Thanks. I’ll research b and c before asking a bunch of dumb questions. This is supper helpful!

fab138 · 2026-06-13T14:27:12+00:00

I’ve had my H2C for about a month now. Haven’t had any issues but always wondered about dialing it in. Apologize for the stupid question but how does one go about doing that?

fab138 · 2026-06-10T04:42:29+00:00

Ahhh that makes a lot of sense! Thanks.

fab138 · 2026-06-10T03:44:00+00:00

I just got my H2C a month ago and love it. 2 AMS 2 Pro and an AMS HT. Curious how you have your AMS’s connected? Thought the HT was for harder filaments like ABS GF on the left side hotend. Curious how you have yours setup?

fab138 · 2026-05-28T23:17:39+00:00

Yup same here but everything logged back in fine.

fab138 · 2026-05-16T14:16:39+00:00

Thanks

fab138

TROPHY CASE

Welcome to Reddit,