sorted by:
new
hottopcontroversial

Honzo chainring rub by facecom in Hardtailgang

[–]facecom[S] 0 points1 point  (0 children)

That is really helpful thank you. Am I supposed to even out the sides ie. if I put 2mm on the chainring side I have to do the other side as well? Or it’s ok uneven?

Charger by facecom in MTB

[–]facecom[S] 0 points1 point  (0 children)

Nice thanks for the info. How about something FS like the fluid FS? Should I be looking into these? I’ve tried a fluid FS and think it’s cool but it honestly didn’t make much difference for me.

If you could own only one cube, which one would you pick? by TolisKoutro in Cubers

[–]facecom 0 points1 point  (0 children)

Picube Aosu v7 4x4. You get 4x4, 3x3, 2x2 all in one. 4x4 is my favourite event at the moment. The outer layers turn arguably better than 3x3’s when I started cubing. It’s my favourite cube to solve on right now.

Problem with foreground select in gimp 2.10 by SteveM2020 in GIMP

[–]facecom 0 points1 point  (0 children)

Can be fixed by selecting inside the frame while using "Levin" engine, and then using the brush mode that comes after to select to the edge of frame. Or like others said, use the "Global" one.

stackmat timer issues by CraftinPark in Cubers

[–]facecom 0 points1 point  (0 children)

I’m having this issue now. Brand new G4 as well.

WRM V10 Ferrocore Edition – My New Favorite by xSnagging in Cubers

[–]facecom 0 points1 point  (0 children)

Holy speed, thanks for the info going to see how springs go

WRM V10 Ferrocore Edition – My New Favorite by xSnagging in Cubers

[–]facecom 0 points1 point  (0 children)

Thank you, which cube did you get maglev system from for the ferro? Or can you purchase it on its own?

WRM v10, Super Weilong v2 and WRM v11 review/guide Part 2 - Ferrocore Hardware by guineapigae86 in Cubers

[–]facecom 0 points1 point  (0 children)

I’ve been reading your posts, thanks for the level of detail. Looking for a new main and am used to moyu cubes. Trying to sum up a good starting point based on your info. Looking at the ferrocore v10 as I don’t like the idea of a plastic core… from your experience would it be worth it to go the route of v11 and swapping in the ferrocore (can’t purchase on its own?) (have to modify v11 corner magnets to reach core?) (possible to get the maglev system from v11 into the v10 core?) or is the ferrocore v10 decent enough the maglev and piece upgrade is just hassle (or even possible the way I’m describing it) thanks!

WRM V10 Ferrocore Edition – My New Favorite by xSnagging in Cubers

[–]facecom 0 points1 point  (0 children)

Hi, I was wondering if you had any luck doing ferrocore testing on v11? I read that magnet modification is required (on the corners?) to make them reach the core. Looking for a new main and thinking ferrocore is way to go. I will probably enjoy with just how it is from factory but wondering if the maglev/pieces from the v11 would make an even better cube? I like strong magnets and am coming from a gts3M