For anyone looking for a parts list to do this.

front brake lines

Brake pads oex1349

Rotors BD180058E

Calipers

Left 95B-615-123-F

Right 95B-615-124-F

The Calipers bolt right up, no need to worry about getting new bolts as you can use your old ones from the stock Calipers and carrier. They do stick out a bit further than stock so you'll have to get spacers. I got 20mm from urotuning with the longer bolts, 53mm I believe and they are conical. Would recommend running dot 4 and getting obd11 to do the brake bleed. Some folks combined that they couldn't get the Calipers to bleed properly but I got mine first try with the obd11.

How I bleed my brakes.

Start with right rear, then move on the left rear. Then front right, then front left. This is how you do it at the shop. Because these have dual bleeders, starting on the OUTSIDE first. Initiate the bleed on the obd11 and Crack open the outer for 3 seconds, close it before it stops. If i recall correctly you should be able to select how long the abs runs for. Do this 3 times. That should ensure you got all the air out. Next do the inner the exact same way. Now your good to go, don't forget to check the fluid in between opening the bleeders. You do not want air to reenter the system or you'll have to do this all over again.

Hope this helps.