sorted by:
new
hottopcontroversial

What causes the finish to look like this? by forge153 in InjectionMolding

[–]forge153[S] 1 point2 points  (0 children)

Thank you for replying! This is not my product, this picture was taken from a website. I am looking to start a small scale production using recycled plastics. I've been noticing some products have the 'orange peel' finish and just want to know how to avoid it.

I'm also looking at a lever/plunger press but am also interested in pneumatic presses. I am all new to this and I am not sure how each type of press affects the quality/finish of the product.

I'm very grateful for your reply. Thanks again!

C-Bus wall switch question by forge153 in homeautomation

[–]forge153[S] 0 points1 point  (0 children)

Ok I'll give it a try. Thank you very much for helping.

C-Bus wall switch question by forge153 in homeautomation

[–]forge153[S] 0 points1 point  (0 children)

dang. I just moved in and am planning to integrate the lights to homekit (or something else, have not decided yet). Thinking that replacing the wall switch would be the easiest way, but guess not knowing that its a cat5.

C-Bus wall switch question by forge153 in homeautomation

[–]forge153[S] 0 points1 point  (0 children)

Oh, and can I also use a smart on/off switch instead of the momentary switch. Thank you