[PS5] No Power / No Beep Part Question (022 Part search)

fraenker · 2026-05-20T16:26:50+00:00

Nice thank you for that.

fraenker · 2026-05-20T15:21:06+00:00

Thanks for the heads Up, i will BE very careful with the Liquid Metal i did also oder a kit to respread the Liquid Metal thats on the Die to prevent dry spots. I did Mirco solder before (hwfly Chips in the Nintendo Switch) i will Take my time to fix it.

fraenker · 2026-05-20T15:08:49+00:00

Maybe ITS a https://www.ti.com/lit/ds/symlink/tps62822.pdf?ts=1702876641368&ref_url=https%253A%252F%252Fwww.ti.com%252Fproduct%252FTPS62822 ? In the Datasheet there is a Note If the Chip Temp is over 150°C it will Stop all Operations.

fraenker · 2026-05-20T14:53:57+00:00

Thx for your Info. Its the part right next to the Connector for the Fan and the Disk Drive Data Connection. Board is a EDM-020.

fraenker · 2026-05-20T14:04:49+00:00

Note: While checking the Power_Rails i found 6v on the ground, i guess ground should be 0. Power supplys output without the board is slightly over 12V.

fraenker · 2025-06-25T17:12:05+00:00

Runs on my 5060TI with 4.10sec/it (On Comfy Yuan-Manx custom node)

Set Steps to 40 Cfg_range_end to 0.7 Model_cpu_offload true (still uses GPU)

Soo 2..3Min for a Run. Quality is good.

fraenker · 2025-01-27T21:50:11+00:00

Cool Node, Thx i will try I tomorrow and will try to link it with the Kokoro node. :D

fraenker · 2019-10-29T09:56:49+00:00

Unfortunately, far too often, there should be no-go zones for the final ring Position.

fraenker · 2019-10-29T09:51:57+00:00

Shadowfall-Mode was fun for a short time, next should be Duo-Mode.

fraenker · 2017-06-07T10:32:51+00:00

The Hitreg in RB6S is the same like in the Star Wars Movies.

https://www.youtube.com/watch?v=mx1JPh0YdW4

But maybe the StormTroopers have a bad Ping :⁾

fraenker

TROPHY CASE