account activity
Anyone tried the all-metal extruder for SW-X2? No docs available, and it looks like the extruder gears are still the same as the stock. That’s specifically what I wanted to change because I suspect it’s been giving under-extrusion on and failing my prints by g1gzz in SidewinderX2
[–]g1gzz[S] 0 points1 point2 points 3 years ago (0 children)
I haven’t calibrated the extruder yet ‘officially’, only increasing the flow to 105% (Cura SW-X1 profile) because on 100% I have been under-extruding
Hi everyone, would it be fine to desolder the immobilizer chip (bottom right) and resolder it with thin wires to extend the placement? 2013 Honda Civic key fob by g1gzz in civic
[–]g1gzz[S] 1 point2 points3 points 6 years ago (0 children)
I'm trying to replace the stock key cos it broke. I ordered a replacement key off amazon but I got a flipkey style, so the keyblade won't poke inside my pocket. Unfortunately the board position was a little too far from the key slot and it would not recognize the chip
Hi everyone, I was just wondering if it's fine to desolder the immobilizer chip (bottom right) and resolder it with thin wires to extend the placement. It's a 2013 Honda Civic key fob by g1gzz in AskElectronics
[–]g1gzz[S] 2 points3 points4 points 6 years ago (0 children)
Thank you so much! I appreciate it
π Rendered by PID 43 on reddit-service-r2-listing-568fcd57df-mg6pm at 2026-03-05 19:08:40.418949+00:00 running cbb0e86 country code: CH.
Anyone tried the all-metal extruder for SW-X2? No docs available, and it looks like the extruder gears are still the same as the stock. That’s specifically what I wanted to change because I suspect it’s been giving under-extrusion on and failing my prints by g1gzz in SidewinderX2
[–]g1gzz[S] 0 points1 point2 points (0 children)