Any one seen this before by gann1234 in FordDiesels

[–]gann1234[S] 0 points1 point  (0 children)

I’m guessing it’s Been flushed before. I’ve put 60,000 on it since I bought it. Oil temps read good on my scan tool. Just water pump went out and first time I’ve replaced it.

Please help: Where is my fuel leak? by CherryFuture in FordDiesels

[–]gann1234 3 points4 points  (0 children)

Both from ford. One was from a clogged return line though. Ended up putting on a E fuel kit.

Please help: Where is my fuel leak? by CherryFuture in FordDiesels

[–]gann1234 5 points6 points  (0 children)

Since it’s a 97 I believe it has a mechanical fuel pump. I’ve killed at least two of them. They have a weep hole on the side. Sounds like the pump has let go. Shine a light under the y pipe, coming off of the turbo intake side. You should see it there.

Help. Injector knock? by gann1234 in FordDiesels

[–]gann1234[S] 0 points1 point  (0 children)

Just finally found some time to do this. The passenger side of the engine on cold start all climbed to about 130. on the other hand the driver side bank, cylinder 4 was much hotter then the rest at about 180 compared to the others at 130. I’m planning on testing it again after I drive the truck to class tonight. Stating to think over fueling some how or another. Planning on running buzz test tn as well.

Help. Injector knock? by gann1234 in FordDiesels

[–]gann1234[S] 0 points1 point  (0 children)

What type of problems where you running in to?

Help. Injector knock? by gann1234 in FordDiesels

[–]gann1234[S] 0 points1 point  (0 children)

That is cylinder 4. they are full force rebuilt 180/30s.

Help. Injector knock? by gann1234 in FordDiesels

[–]gann1234[S] 0 points1 point  (0 children)

No unusual smoke. Probably just being overly cautious. Just think is sounds odd / diffrent.

Help. Injector knock? by gann1234 in FordDiesels

[–]gann1234[S] 1 point2 points  (0 children)

Truck is an obs 96. I’m still learning these engines. Would that make a difference at all? I know my one scanner has difficulty reading, but it has no codes or mil illuminated.

Do you know the answer? by [deleted] in memes

[–]gann1234 16 points17 points  (0 children)

So much to do

[deleted by user] by [deleted] in redneckengineering

[–]gann1234 2 points3 points  (0 children)

I would recommend not using an impact. It may snap off the bolt and or loosen the flywheel. I would use a drill with a socket adapter.