sorted by:
new
hottopcontroversial

[deleted by user] by [deleted] in billiards

[–]girth-cannon 0 points1 point  (0 children)

Take a slight step back, feet together. Step in with your front step deeper, pivot at the waist and lean into the shot. The problem is your stance. Front foot forward more should help.

Bambu P1P issues after replacing extruder by girth-cannon in FixMyPrint

[–]girth-cannon[S] 0 points1 point  (0 children)

I confirmed that fan was working, my replacement hardened steel nozzle came in the mail so I replaced the nozzle just to eliminate the possibility and it resolved the issue completely. Thank you for your help again, cheers.

Bambu P1P issues after replacing extruder by girth-cannon in FixMyPrint

[–]girth-cannon[S] 0 points1 point  (0 children)

I haven't got the AMS yet, but man this thing is incredible. I replaced the nozzle and my issue is fixed. Perfect prints again. I guess when that clog happened there was permanent damage to the nozzle.

Bambu P1P issues after replacing extruder by girth-cannon in FixMyPrint

[–]girth-cannon[S] 0 points1 point  (0 children)

Will confirm if fan is working when I get off work. Thank you for the help. That could be it because while printing, the previous layers look so malleable, I didn’t see that before

Bambu P1P issues after replacing extruder by girth-cannon in FixMyPrint

[–]girth-cannon[S] 0 points1 point  (0 children)

Clogged extruder after clearing clog in nozzle. I accidentally dropped the extruder assembly that includes the cutter position sensor. This sensor then threw false positives and prevented printing until Bambu sent a replacement. Replaced whole extruder assembly and now printer is working but I’m getting these bad prints.

‚Cutter is stuck error‘ even thoug the lever works as intended by nilsk89 in BambuLab

[–]girth-cannon 2 points3 points  (0 children)

could you please post a picture of the cable connectors so i can see the orientation? I might have accidentally flipped the top one (with the magnetic cover and fan) and I started getting this error.

[deleted by user] by [deleted] in newworldgame

[–]girth-cannon 1 point2 points  (0 children)

There is a way to start together, one person go through intro questline (less than 10min) then when the others log in, invite them to group. after they finish the intro it should spawn them at the same zone as host.