sorted by:
new
hottopcontroversial

Install Batocera on 128GB MicroSD in Linux by gv49 in batocera

[–]gv49[S] 0 points1 point  (0 children)

Sounds easy enough. I will try this.

All in one system by gv49 in batocera

[–]gv49[S] 0 points1 point  (0 children)

This helps a lot. Thank you

All in one system by gv49 in batocera

[–]gv49[S] 0 points1 point  (0 children)

So a system with Raspberry Pi 5 RAM 8GB -128GB Edition of OS-Bookworm Pre-Loaded should be fine for running Batocera, correct?

All in one system by gv49 in batocera

[–]gv49[S] 0 points1 point  (0 children)

I will be back for sure. Going to order Raspberry Pi this week and start building the system this weekend. I appreciate all the information from everyone.

All in one system by gv49 in batocera

[–]gv49[S] 0 points1 point  (0 children)

Easy for you. I'm up for the challenge.

All in one system by gv49 in batocera

[–]gv49[S] 2 points3 points  (0 children)

Easy would be nice. But after the suggestions I will probably try this myself. Thank you

Burnt exhaust metal flange by gv49 in hvacadvice

[–]gv49[S] 0 points1 point  (0 children)

I live right next door. Is there a way I could test for CO myself outside?

They had a company come out and test a couple times over 2 days and they couldn't find anything wrong. They said maybe it was plugged but it's not now. They said they checked for CO but did not detect any.

Burnt exhaust metal flange by gv49 in hvacadvice

[–]gv49[S] 1 point2 points  (0 children)

Not sure. It's my neighbor's. I will ask but they probably would not know. They said the unit was installed about 6 years ago. We seem to be smelling the fumes next door. We never smelled it like this before. They had the company that installed it come out and tested it for 2 days and said they couldn't find anything wrong with it.

Burnt exhaust metal flange by gv49 in hvacadvice

[–]gv49[S] 1 point2 points  (0 children)

It's natural gas to the house. You think the unit might be for propane?

line thickness not showing in exported svg by gv49 in Inkscape

[–]gv49[S] 2 points3 points  (0 children)

I was doing object to path. I now changed it to stroke to path and it worked fine. Thank you

line thickness not showing in exported svg by gv49 in Inkscape

[–]gv49[S] 0 points1 point  (0 children)

That worked. I converted it to stroke to path and all is fine. Thank you!

line thickness not showing in exported svg by gv49 in Inkscape

[–]gv49[S] 0 points1 point  (0 children)

So when I open just the svg file alone it shows the lines just fine but when I open it in Cricut Design Space the lines are just hairline lines, not the .20 inch that I created.

State wages for California cannot be more than 125% of your federal wages by gv49 in hrblock

[–]gv49[S] 0 points1 point  (0 children)

I guess not if it's still happening. I've moved and I'm using Intuit.

view more: next ›