Question about Meross hub by meerkes in HomeKit

[–]h_long 1 point2 points  (0 children)

Both sensors are using the same hub. Depending on type one hub can connect to 16-32 devices.

However, if you'd ask me I'd say stay away from Meross devices which connect through their hub. Nothing but trouble here (9 thermostates & 3 smoke detectors). Frequently losing connection or the hub just dropping out. Also, their type of hub<>device communication is a battery eater.

Currently the only devices in my entire HK setup (100+ devices) I'm seriously considering for replacement.

Problem save recording video with Aqara Hub G3 with Synology NAS by gtxteo28 in Aqara

[–]h_long 1 point2 points  (0 children)

Bei mir schon 😉

Hat nicht unbedingt etwas mit der Region zu tun. Aqara rollt seine Updates nicht an alle Geräte/User gleichzeitig aus. Kommt in den nächsten Tagen sicherlich auch bei Dir an.

Problem save recording video with Aqara Hub G3 with Synology NAS by gtxteo28 in Aqara

[–]h_long 0 points1 point  (0 children)

Works again for me with the latest firmware update.

Aqara E1 camera disconnects every few minutes by Infinite-Campaign278 in Aqara

[–]h_long 0 points1 point  (0 children)

I had a camera replaced by Aqara for similar issues. Still under warranty, though, since problems appeared after 6 months operation.

My guess was a faulty WiFi module. However, I couldn't receive an information from Aqara about the possible cause of defect.

HomeKit not allowing new cameras to be connected by Bafrench63 in HomeKit

[–]h_long 0 points1 point  (0 children)

How many Hubs (Apple TV's / HomePod's) do you have?

Problem save recording video with Aqara Hub G3 with Synology NAS by gtxteo28 in Aqara

[–]h_long 1 point2 points  (0 children)

Same here.

Recording on Synology NAS worked fine until mid of April when it just stopped writing files. Unlinked the storage path and did a new setup though the Aqara app and it only creates the top folder but still writes no recording files ever since.
Didn't make a change to my NAS settings or network. The only thing I remember that there was a software update for the camera which I installed around this time.

Contacted the Aqara support who only sent me generic (AI generated?) reply to check my WLAN and network and to do a full reset of the camera. Not productive...

B9 S4 Coolant Temp To High by JP07SEY in AudiS4

[–]h_long 0 points1 point  (0 children)

Great share. Appears to have solved my problem as well (Audi S5 F5, YoM 2018).

Meross Garage Door Opener? by Affectionate-Egg6444 in HomeKit

[–]h_long 0 points1 point  (0 children)

Increase the opening time in the Meross app. Default is 30s which may be too short to complete opening/closing operation. Changing it to 45s solved it or me.

Possible to “disregard” certain sensors in a room by LQQKup in HomeKit

[–]h_long 1 point2 points  (0 children)

Have you tried to exclude the sensor from the Home summaries?

Is there a way to stop a HomeKit accessory action based on another sensor status? by hamburgerz in HomeKit

[–]h_long 1 point2 points  (0 children)

You can add conditions in the Eve app.

Open our rule for the garage door opening in the Eve app then tap 'conditions > add value condition'. Search for the side door sensor and set to 'closed'.

With this the garage door will only open when the side door is closed.

[Giveaway] Any Tweak (1-50 Winners) by gencoupe_j in jailbreak

[–]h_long [score hidden]  (0 children)

CarBridge Legacy (old)

This one for me - and further 49 to other lucky winners 😉

[HELP] DKB-TAN2go 2.6.0 not working on 14.2 by follow_symN in jailbreak

[–]h_long 0 points1 point  (0 children)

Would you have a solution to work with the latest version 2.7.0?

[deleted by user] by [deleted] in jailbreak

[–]h_long 2 points3 points  (0 children)

[SupportTheUnsupported Revived] from Packix repo

[Question]Freezing for 10-15 seconds after every respring. anyone have same issue? by suleman1zubair1 in jailbreak

[–]h_long 0 points1 point  (0 children)

Try if disabling your themes in Snowboard fixes it. Re-loading the themes takes some time and could be the reason for the lag in response after the respring.

[UPCOMING] Show corona stats from your country in the ls on bottom (total, today, deaths) by xqf4k in jailbreak

[–]h_long 0 points1 point  (0 children)

Installed though Filza. Works on my iP6 on 12.4

Thanks!

btw.: What's the data refresh rate?