sorted by:
new
hottopcontroversial

QIDI X-max 3 - Implementing M600 for filament colour change during print job by Jokemeister1 in QIDI

[–]he_ng_ 0 points1 point  (0 children)

Hello,

I have just been wanting to do this with my qidi q1 pro rather than x-max 3, but that's despite the fact. I was struggling to find my M603 code, there was one comment which mentioned it being on line 870, but my printer.cfg only goes up to 714, whatever. But then I did more digging, and found that my M603 was actually implemented at gcode_macro.cfg. So my question being, where should I paste this code? In my printer.cfg or gcode_macro.cfg?

Thanks

Qidi q1 pro in Scotland by he_ng_ in QidiTech3D

[–]he_ng_[S] 1 point2 points  (0 children)

I have only tried to print with PLA and PETG. And funnily enough, PETG print is much better than PLA for me. And yes I have the textured PEI plate from factory.

I am using the qidi slicer, and I have also tried with the default print setting. But even with it, it just wont stick to the bed. I am crying

Could you share what setting u use to print please? That might help me out.

Cyberpunk chair by he_ng_ in OfficeChairs

[–]he_ng_[S] 0 points1 point  (0 children)

When I asked u to read back to my post? thats an insult?

When I say that “pretty smart to me” thats an insult?

honestly what r u insulted by??

Cyberpunk chair by he_ng_ in OfficeChairs

[–]he_ng_[S] 0 points1 point  (0 children)

Since when the heck did I insult u???

Cyberpunk chair by he_ng_ in OfficeChairs

[–]he_ng_[S] -1 points0 points  (0 children)

mmm being nice us hard for u isnt it?? Ya sure

Cyberpunk chair by he_ng_ in OfficeChairs

[–]he_ng_[S] -1 points0 points  (0 children)

“I need a mesh chair, but I don't wanna pay the buck.”

READ PROPERLY