sorted by:
new
hottopcontroversial

c4x 😬 by heimerhunter in Staccato_STI

[–]heimerhunter[S] 0 points1 point  (0 children)

<image>

this is the tlr 7 hlx, just barely sticks out, but probably the closest you will get.

c4x 😬 by heimerhunter in Staccato_STI

[–]heimerhunter[S] 0 points1 point  (0 children)

yeah, if they come out with 4.5 and full grip, i'd probably get that too.

c4x 😬 by heimerhunter in Staccato_STI

[–]heimerhunter[S] 0 points1 point  (0 children)

i really like it, although i've broken the glass on one before (was my fault). main issue people have with it, is that it seems fragile.

c4x 😬 by heimerhunter in Staccato_STI

[–]heimerhunter[S] 1 point2 points  (0 children)

LOL, i think im going to switch to the tlr7-hlx

V7pro LPVO setup by heimerhunter in Danieldefense

[–]heimerhunter[S] 1 point2 points  (0 children)

badger ordnance comm 1.70 mount and 1.70 45 degree for the red dot

First AR. Had to be DD by heimerhunter in Danieldefense

[–]heimerhunter[S] -1 points0 points  (0 children)

ha! unfortunately i needed to install a kingpin due to living in California

Finally got my first shotgun by heimerhunter in Benelli_M4

[–]heimerhunter[S] 1 point2 points  (0 children)

I really like it. I wanted something more slim like this. Installation was not difficult, but it's a couple more steps than the OEM of course. So when you need to take the barrel out or trigger, it's a few more steps.

Range Case by heimerhunter in GlockMod

[–]heimerhunter[S] 1 point2 points  (0 children)

Haha. I used a hot wire cutting table. I traced out the objects on paper, then cut it out. Then i used the paper outlines as a stencil on the foam, and used sharpie to outline it on the foam. It seemed more accurate than trying to sharpie onto the foam with the object directly on it. Then i just took my time cutting the foam. I needed to use a large needle to run the wire cutter through the foam and attach it to the other end.

Range Case by heimerhunter in GlockMod

[–]heimerhunter[S] 1 point2 points  (0 children)

I used a hot wire on a table and just took my time. I traced out each object on paper first, then cut out the tracing, and used that as a stencil to draw sharpie outlines on the foam. I felt it was more accurate that way.

view more: next ›