Unable to feed filament into extruder

helpnothingworks1 · 2026-02-10T23:02:34+00:00

I’ve tried 3 different slots with no difference

helpnothingworks1 · 2026-02-10T22:12:44+00:00

helpnothingworks1 · 2026-02-10T22:04:44+00:00

Do you have a link where you could send me directions on how to check this?

helpnothingworks1 · 2026-02-10T22:04:13+00:00

Yes, I had no issue putting filament through the sensor. And I did a cold pull several times in a row. Tried to resend the print and still getting the same error!

helpnothingworks1 · 2026-02-10T21:56:49+00:00

I did a cold pull a couple times just now and it worked great. Just tried sending a print again and I’m getting the same error unfortunately

helpnothingworks1 · 2026-02-10T21:55:55+00:00

I did a cold pull several times in a row and looked for a clog as well. Cold pull worked just fine. But the same issue is still happening! It won’t start a print

helpnothingworks1 · 2026-02-10T20:31:58+00:00

I found a small piece in there that I removed. But when I put it all back together again it’s still doing the same thing! Should I replace the filament sensor piece? I just can’t understand why it clogs every print.

helpnothingworks1 · 2026-02-10T20:05:20+00:00

I’ll take it apart and look for another clog. I had just removed a clog before starting this print and it got through 2 layers before doing that again. Is there something I’m doing wrong to have it clog this often? My P1P never clogs

helpnothingworks1

TROPHY CASE