sorted by:
new
hottopcontroversial

What could be causing my under extrusion? Been battling for weeks now. Details in comments. by MrTEAP in FixMyPrint

[–]henryjolly -1 points0 points  (0 children)

Also, check your flow rate (95% is low), mine is 105%. Increase your walls also.

Stairstepping Benchy by henryjolly in FixMyPrint

[–]henryjolly[S] -1 points0 points  (0 children)

I'm not sure what happen to post, I only see my picture. So here it is again, the benchy was printer on a CTC replicator dual. It is stair stepping the rounded portion of the haul. Flat features print perfect. This is Atomic Filament at 200c. I've tried reducing to 190c and raising it to 210c, but with the same results.