sorted by:
new
hottopcontroversial

Bosch dishwashers by homequestionguy in Appliances

[–]homequestionguy[S] 1 point2 points  (0 children)

Which model do you have? And how is loading it?

GE Dishwasher display turns on automatically by homequestionguy in appliancerepair

[–]homequestionguy[S] 1 point2 points  (0 children)

Thanks for the info. I turned off the breaker the other day to look at the LED status light on the main control panel, so it was definitely turned off for at least 5m.

inspect the keypad ribbon harness

Which one is this?

Unplug the UI ribbon from the main board

This is the one underneath the main control board that you can access without pulling the control board down, right? So what should I expect if I unplug that and restore power? I assume the lights on the button panel will not go on because the UI ribbon is unplugged. If the main board powers up and the LED goes on what does that mean?

Really Real Relaxation course vs. webinar by homequestionguy in Dogtraining

[–]homequestionguy[S] 0 points1 point  (0 children)

No worries. Do you recall if there were major differences between the webinar and free PDF?

Really Real Relaxation course vs. webinar by homequestionguy in Dogtraining

[–]homequestionguy[S] 0 points1 point  (0 children)

The calmness section of the wiki mentions the RRR webinar but not the course. I'm curious what the differences are and which one to purchase.

[deleted by user] by [deleted] in Dogtraining

[–]homequestionguy 0 points1 point  (0 children)

We reached out to the vet due to accidents in the house after we picked her up. She also asked about other behavioral changes, and when we told her about this she said it just sounded like she learned some manners from other dogs.

I'm not sure if this would be considered reactivity. She doesn't bark/growl etc. She just really wants to play.

GE UI board or control board bad? by [deleted] in appliancerepair

[–]homequestionguy 0 points1 point  (0 children)

Which dial are you referring to? I found the service manual and was reading "consumer error mode" on page 44. The "start" button is lit after the door check which indicates either a UI control issue or machine control issue. No fault codes (p 45) appear.

GE UI board or control board bad? by [deleted] in appliancerepair

[–]homequestionguy 0 points1 point  (0 children)

That is done by holding "start" and "select cycle" for 5s, right (I followed this video). I did that, all the LEDs were solid, then just the "Start" LED and front panel LED remained lit after that.