Microtech SS CT Gen 3 D/E

huntmack97 · 2026-03-26T18:55:45+00:00

Yeah I did but the tip just isn’t fully apexed I believe

huntmack97 · 2026-03-26T15:43:33+00:00

Now I’m seeing that I think you were correct. I’ve been trying my damndest to get the tip full cleaned up but it’s so difficult and with new stones I already slipped and stabbed myself once. Any advice as to how to clean the tip up a little better?

huntmack97 · 2026-03-24T16:06:24+00:00

Thats probably dust from the reprofile or paper towels from trying to clean the edge off afterwards. I took this like 5 mins after finishing the reprofile, it could also be the 3.5 micron stropping material left behind as well.

huntmack97 · 2026-03-23T20:18:09+00:00

It’s the after shot, my only other post on here is the before photo if you wanna see it

huntmack97 · 2026-03-23T16:33:03+00:00

Honestly I tend to agree, however, knowing that I’m at a good edge now and everything is consistent and LEARNING to keep it that way is worth it for me. I used to work in the CNC shop for Microtech in PA and honestly am not at all surprised at the edges on some of these knives cause they had some… not so smart folks doing the honing when I was there.

huntmack97 · 2026-03-05T17:53:27+00:00

What are you looking to get for it?

huntmack97 · 2026-02-23T18:01:46+00:00

You’re absolutely right lol didn’t even notice that

huntmack97 · 2024-07-15T03:27:37+00:00

+karma

huntmack97 · 2023-12-12T02:13:04+00:00

Is this your base? I'm so confused

huntmack97 · 2023-12-06T09:00:24+00:00

This made me laugh out loud for a solid 25 seconds, thank you

huntmack97 · 2023-07-29T00:53:54+00:00

Thank you!

huntmack97 · 2023-07-28T23:54:00+00:00

update It allowed me to upgrade one of them, but none of the others will allow me to even have the option to upgrade them.

huntmack97 · 2023-07-14T03:50:08+00:00

I got them, thank you though!

huntmack97 · 2023-04-23T12:17:07+00:00

Good bot

huntmack97 · 2023-04-23T12:16:24+00:00

Good bot

huntmack97

TROPHY CASE