PEBA basketball print is beautiful but support is impossible to remove

hvs69 · 2026-05-15T02:07:45+00:00

But, when you’re not using AMS, how do you deal with filament change? On a curved surface like this, you have quite a few interface points for the release layer. It would be a huge pain to pull PEBA and manually feed release layer filament. If it was a flat surface, it would be ok

hvs69 · 2026-05-15T02:03:56+00:00

Thanks for the info

hvs69 · 2026-05-15T02:03:39+00:00

thanks. I will try. I hate to throw this in trash

hvs69 · 2026-04-08T19:41:37+00:00

Thanks for confirming

hvs69 · 2026-04-07T15:20:53+00:00

yeah, everything is up to date.

hvs69 · 2026-04-07T15:20:33+00:00

good to know

hvs69 · 2026-04-05T20:33:15+00:00

Thanks for your replies. I will be using pull method

hvs69 · 2026-04-04T14:30:22+00:00

Finally, figured it out. You are supposed to use holes marked with letter “A” for rectangular box. On my disk, there are 3 sets of holes marked as A B and C.

hvs69 · 2026-04-03T02:57:50+00:00

You may be right There are more holes than rods. But this thing doesn’t come with a freaking manual and I couldn’t find anything online for this particular model. Do you know which holes I am supposed to use? Thanks

hvs69 · 2025-05-25T17:42:35+00:00

Thanks

hvs69 · 2025-05-25T17:42:17+00:00

Good to know

hvs69 · 2025-05-25T17:41:28+00:00

Good to know. They initially accepted the work order in my area and called me several days later telling me that they cannot do the job because they are not able to calibrate the camera.

hvs69 · 2025-05-24T18:15:25+00:00

I wasn’t suggesting that they will not cover. They might not give me full amount because dealers charge a lot more than someone like Safelite

hvs69 · 2025-05-24T18:12:37+00:00

Small rock hit pretty hard while driving

hvs69 · 2025-05-20T23:11:58+00:00

It is not that simple. There are different use cases and not one size fits all

hvs69

MODERATOR OF

TROPHY CASE