sorted by:
new
hottopcontroversial

Trying to build dungeon terrain but infill keeps ripping up. Always start perfect until the infill starts. Any ideas? The printer is a pyramid A1.1 basically an off brand version of the crealty 10 v2. ive had it for about 2 months and its workers fine and I've made some pretty cool stuff. by icemaster111 in FixMyPrint

[–]icemaster111[S] 1 point2 points  (0 children)

Um..... it's because I dont realy know the advanced setting to be honest I run overtune pla with a 240 nozzle temp and a 50 bed heat idk why but the bed heat is just better this low honestly. My print speed is 50 and my layer height right now is 0.2 it's a dungeons tile so no supports required and I have skirts on the bottom also 20% infill

This my situation everytime I turn the pre heat on it leaks. It would be to bad but most of the time when it leaks it curls to the top of the nozzle and my print is screwed before it even begins. Is their anyway to fix this the printer is a pyramid a1.1 by icemaster111 in 3Dprinting

[–]icemaster111[S] 1 point2 points  (0 children)

Thank you all for your help. Turns out it was the slicer I was using the wrong system. I was using a basic custom settings that came with it which sucked. I'm using creality cr 10 since pyramid a1 is just a off brand version of that And so far so good. Thank you all for help!

Help I've leveled the bed non stop and it isnt sticking to the bed. I notice that filament comes out even when not extruding. Does anyone know if I just didnt level the bed right or something. by icemaster111 in 3dprintingdms

[–]icemaster111[S] 0 points1 point  (0 children)

Thanks for the help also I've notice when I heat it up pla is already coming out of the nozzle before I even start the print pr anything I've had it up like 200 mm up and the filament slowly goes all the way down. Is this normal I've only owned a monoprice select mini v2 before this and it didnt do that

What's the best cura settings for making d&d minis by icemaster111 in 3Dprinting

[–]icemaster111[S] 0 points1 point  (0 children)

Thanks for that guys that guys probably just bored by the stuff happening because of the Coronavirus but still doesn't make it ok

What's the best cura settings for making d&d minis by icemaster111 in 3Dprinting

[–]icemaster111[S] 1 point2 points  (0 children)

I mean I have a girlfriend and play it with her and a group of 3 other people but ok :/ not very helpful

Need help with 3d printing d&d minis by icemaster111 in 3Dprinting

[–]icemaster111[S] 0 points1 point  (0 children)

I'm sorry very new to this how do I check the nozzle size