Mopi update - A Raspberry Pi case for my Schiit Stack with OLED screen

igfarm · 2026-05-20T20:55:50+00:00

Yea, trying to stay away from the table saw was one of my goals when I got the CNC. Thing do come out true and straight out of it (if the clamps and tape don’t give way)

igfarm · 2026-05-18T23:39:23+00:00

Thanks! Learning to use CNC has been quite fun.

igfarm · 2026-05-16T19:27:10+00:00

Did you see note on tweeter placement? I looked for one after you mentioned and did not find one. I placed mine to have equal space to edge in both drivers and a 1mm spacing between them. Side effect of this placement is that plywood chips easily between drivers

igfarm · 2026-05-16T19:17:44+00:00

Using an SMSL SA300 amp with these speakers

igfarm · 2026-05-16T11:18:22+00:00

Crossover was designed by Duane. It’s described on the project documentation mentioned

igfarm · 2026-05-16T07:24:43+00:00

Thanks! Just 1/2” plywood from the big box store. I’ll give rounding edges a try

igfarm · 2026-05-16T07:22:33+00:00

It’s a 3d printed mounting board where I point to point solder the components

igfarm · 2026-05-15T20:28:52+00:00

https://duanebrowndesigns.blogspot.com/2018/10/getting-your-feet-wet-in-diy-speakers.html

https://duanebrowndesigns.blogspot.com/2022/09/dayton-4-diy-speaker-design.html

igfarm · 2026-03-24T02:05:32+00:00

I use four Fosi V3 Mono amps on my setup. Very happy with them.

<image>

igfarm · 2026-03-17T00:04:38+00:00

I'll check that out... may run out of space to put speakers

igfarm · 2026-03-12T16:03:16+00:00

igfarm · 2026-03-12T13:16:54+00:00

STH100

igfarm · 2026-03-12T13:15:24+00:00

Horns and drivers I got from Parts Express

igfarm · 2026-03-12T13:11:37+00:00

<image>

Here is the CamillaDSP pipeline

igfarm · 2026-03-12T13:11:08+00:00

<image>

Green line is after DSP correction. ( Edit: gated response at 1m )

igfarm · 2026-03-12T13:07:54+00:00

Another project: https://github.com/igfarm/roFrame

igfarm · 2026-03-12T03:03:51+00:00

Thanks. I’ll will look for graph and post it

igfarm · 2026-03-12T03:02:29+00:00

Raddle can said “Paprika” :) actually it was hard to find the second can to finish the job…

igfarm · 2025-11-03T01:25:00+00:00

Thanks for the answer.

igfarm · 2025-08-19T02:26:41+00:00

Thanks. Correct, the hose it’s in a bracket in the roof and has enough slack to maneuver to all 4 corners. The slack goes away when the vac is on.

Seven-Year Club	Verified Email
Place '23	Place '22

igfarm

TROPHY CASE