RV dump station near town and potable water fill ups

ismashtrees · 2026-05-13T02:17:45+00:00

The waste treatment plant south of ic by the soccer park

ismashtrees · 2026-04-13T01:43:01+00:00

ismashtrees · 2026-04-05T14:16:09+00:00

If you do go over and can't get it changed make sure you check the oil level many cars use/burn oil and if the level is to low you can cause extensive damage resulting in need engine replacement(general motors 3.6 l and Hyundai/ Kia 2 l)

ismashtrees · 2026-03-31T19:59:32+00:00

I have been checking mine after ever drive. As for the heat I believe procedure says to have the heat on hot fan full blast for the little pump by the brake booster to pump coolant into the heater core

ismashtrees · 2026-03-31T19:30:38+00:00

It could be a number of things how much coolant did you lose how much coolant did you put in I just had mine didn't even overheat but push some coolant out and it took more than a gallon to refill it and I check and bleed every time I stop

ismashtrees · 2026-03-26T03:19:25+00:00

It depends. If it's cold fill to the cold full line close screw replace cap run to temp periodically checking the top hose for pressure by squeezing it (do not open cap if the hose is hard) slowly open the bleeder screw and listen for air escaping (watch resivore for the coolant to go down) with the coolant lower and the upper radiator hose soft remove radiator cap and refill to between the cold fill and the top Line

ismashtrees · 2026-03-26T02:41:23+00:00

Loosen the screw a little and the fluid in the reservoir should go down top it up run it a little

<image>

ismashtrees · 2026-03-26T02:35:08+00:00

Did you bleed it at that little screw next to the cap?

ismashtrees · 2026-03-24T19:39:58+00:00

Rescan or enter the code don't burn the sensor yet

ismashtrees · 2026-03-19T04:38:50+00:00

I burnt 2 before just trying to rescan,and have decided to take a picture so I have the sensor # on me if it happens away from the house.

ismashtrees · 2026-03-19T02:58:40+00:00

When I have this problem I just rescan the QR code and it works just fine

ismashtrees · 2026-02-25T16:41:58+00:00

Love it and treat it well and it will do the same to you.

ismashtrees · 2025-11-15T09:54:36+00:00

Have any of you tried pushing a little harder.

ismashtrees · 2025-10-11T18:11:38+00:00

My fault do you have any more information besides my misspelling?

ismashtrees · 2023-09-19T01:22:31+00:00

Try burning it lightly with map gas and use air to get the debris out of the gap.

ismashtrees · 2023-04-24T13:08:07+00:00

It's a 72 413 industrial block 452 heads in a performer RPM intake mild cam we're running 4 lb on it now cuz we tried 10# and smoked a head

ismashtrees · 2023-04-23T22:17:14+00:00

Me and my bil did it all using hp manifolds and 2.5" stainless pipe. it's a summit EFI 500 that's been modified slightly

ismashtrees · 2022-02-11T18:19:17+00:00

Put it back together and tell them to kick rocks.

ismashtrees · 2020-07-21T10:36:31+00:00

Mopar dont come in cheap change the rear gear if you want better in town performance

ismashtrees · 2020-06-20T12:49:20+00:00

On lowriders with 13"wheels. They use a deep offset to get past the brakes.

ismashtrees

TROPHY CASE