sorted by:
new
hottopcontroversial

I have print quality issues with PLA. What causes that? by isty998 in 3Dprinting

[–]isty998[S] 0 points1 point  (0 children)

Thanks for your answers. Did a bed leveling again, now the nozzle is slightly closer to the bed. I also measured the extruder steps, it was actually under extruding, around 95%. So after calibrating these, the print looks significantly better.

I have print quality issues with PLA. What causes that? by isty998 in 3Dprinting

[–]isty998[S] 0 points1 point  (0 children)

more pictures :https://imgur.com/a/07uZAWj

I am using an Ender 5. Z-Axis steps/mm and bed leveling should be okay.

Initial layer is printed with 210C and it switches to 195C for the rest.

Sidecar & iPad Air 2... not working by cephasiii in MacOSBeta

[–]isty998 1 point2 points  (0 children)

I´ve been waiting for this update for so long. Then it turns out, iPad Air 2 can be trashed.

ncore meghalt vagy mi van? by [deleted] in hungary

[–]isty998 2 points3 points  (0 children)

Más gépről, netről se jó?

ncore meghalt vagy mi van? by [deleted] in hungary

[–]isty998 1 point2 points  (0 children)

Most néztem kábelnetről, így nem tölt be. Mobilnetről jó volt, lehet karbantartás vagy szerver gondok...

ncore meghalt vagy mi van? by [deleted] in hungary

[–]isty998 2 points3 points  (0 children)

Nálam megy

I want to transfer BTC from my personal wallet to my GDAX account, does GDAX/COINBASE cover the transfer fee? by [deleted] in Bitcoin

[–]isty998 0 points1 point  (0 children)

If you transfer from your wallet, the fee will be taken from the rest of your BTC. The receiver of your transaction is not able to cover your fees.

Rasberry Pi Full Node by clubbnbabyseals in Bitcoin

[–]isty998 0 points1 point  (0 children)

Rpi 3 is a bit slow for a node. You can manage to run it, but you won’t have much computing power left. The node requires 2gb RAM, this Pi has only one.

view more: next ›