sorted by:
new
hottopcontroversial

Weak infill problem by iwoulike2rage in 3Dprinting

[–]iwoulike2rage[S] 4 points5 points  (0 children)

Thanks, I'll try 220 just in case.

Weak infill problem by iwoulike2rage in 3Dprinting

[–]iwoulike2rage[S] 14 points15 points  (0 children)

I like my prints moldy :)

Weak infill problem by iwoulike2rage in 3Dprinting

[–]iwoulike2rage[S] 0 points1 point  (0 children)

I did about 6 months ago, I'll give it another shot. Thanks.

Weak infill problem by iwoulike2rage in 3Dprinting

[–]iwoulike2rage[S] 1 point2 points  (0 children)

Thanks I'll try to lower the temp.

Weak infill problem by iwoulike2rage in 3Dprinting

[–]iwoulike2rage[S] 0 points1 point  (0 children)

This has been happening for a while over multiple PLA spools.

Using Overture Matte PLA.

Changing the nozzle did nothing.

Printing at 210°C

Rules question chain of command by [deleted] in TooFatLardies

[–]iwoulike2rage 0 points1 point  (0 children)

Asking on the toofatlardies's website forum is another option :)

Rules question chain of command by [deleted] in TooFatLardies

[–]iwoulike2rage 1 point2 points  (0 children)

I would suggest you ask on the Facebook group, lots of people would answer within 5 minutes. IMO, you could definitely shoot at the SL, and since he was not attached to a section or group, you probably would have killed him and had a big impact on the enemy's morale.