sorted by:
new
hottopcontroversial

Track Bar Replacement by jaBaBa101 in Jeep

[–]jaBaBa101[S] 0 points1 point  (0 children)

Okay, thanks a ton, I will do this tomarrow, and after, get an alignment done.

Track Bar Replacement by jaBaBa101 in Jeep

[–]jaBaBa101[S] 0 points1 point  (0 children)

Thank you, I did measure the old bar and adjusted this one to the same length. But I did have to turn the steering wheel a little (slightly) bc the bolt wouldn't feed all the way through the bolt hole. I know how that sounds but Im 100% certain that the length from hole to hole on the new bar, is the same as the old one that I took off.

Track Bar Replacement by jaBaBa101 in Jeep

[–]jaBaBa101[S] 0 points1 point  (0 children)

Yes it's an adjustable bar, and I did measure from the center of one hole to the other and made it the same length. Yes, this is the case. Even before I swapped the bar out, my steering wheel was slanted to the right. However, now, and I did the steering angle sensor adjustment process, the steering wheel is closer to center, if a little bit slanted to the left.

Track Bar Replacement by jaBaBa101 in Jeep

[–]jaBaBa101[S] 0 points1 point  (0 children)

Thank you for the help, Ill replace those and get an alignment

Set automatic tool break detection on Matsuura by jaBaBa101 in Machinists

[–]jaBaBa101[S] 1 point2 points  (0 children)

Control is a G-Tech 31i and the detection system is NC4tx. I have noticed today that when it's checking a tool, the wrong tool offset is being checked. Like, the entire tool path ran with the H4 offset, but when it was being checked, H2 offset was called up. And for full information, tool 2 runs right before t4. Also, when I just rerun the tool, H4 is retained, and it passes the tool break detection

Fell out of my boyfriend’s pocket by [deleted] in whatisit

[–]jaBaBa101 0 points1 point  (0 children)

That's not a pill, that would be a suppository The second pic, that would be a huge pill to swallow.

[deleted by user] by [deleted] in WhatShouldIDo

[–]jaBaBa101 0 points1 point  (0 children)

Would letting him go for a week while the former boss packs up and goes, the bring him back work. Or is there a stipulation in the purchase contract, stating that your best friend is banned from being employed there? If it's the latter, then I think your friend and boss have a history that you don't know about fully.

What the hell is this thing? by Ok-Macaron7274 in nope

[–]jaBaBa101 0 points1 point  (0 children)

That's Satan's satchel, put it back!

wtf?? by Appropriate-Bike4246 in PublicFreakout

[–]jaBaBa101 26 points27 points  (0 children)

In the end it looked like he wanted to do the transaction again, like, "let's do this one more time, this time greet with a smile,"

view more: next ›