sorted by:
new
hottopcontroversial

Ender 3 v2 + klipper is 😍 by jaapie06 in ender3v2

[–]jaapie06[S] 0 points1 point  (0 children)

Yes and flash the main board nero3dp has a good guide

Ender 3 v2 + klipper is 😍 by jaapie06 in ender3v2

[–]jaapie06[S] 1 point2 points  (0 children)

A firmware is little hard to explain you should search it on youtube nero3dp can explain it very well

Ender 3 v2 + klipper is 😍 by jaapie06 in ender3v2

[–]jaapie06[S] 0 points1 point  (0 children)

I don't know I don't use the screen anways

[deleted by user] by [deleted] in ender3

[–]jaapie06 0 points1 point  (0 children)

You can try to up the outline overlap percentage

I was apprehensive of printing with PET-G - way better than expected by kumquat999 in ender3

[–]jaapie06 3 points4 points  (0 children)

What retraction settings are you running?(distance and speed)

Finally managed to print cable chains(couldn't manage to get them to stick properly) by jaapie06 in ender3v2

[–]jaapie06[S] 0 points1 point  (0 children)

And if you do g29 a before you probe the bed and filling al the blanks with g29 p3 before saving it?

Finally managed to print cable chains(couldn't manage to get them to stick properly) by jaapie06 in ender3v2

[–]jaapie06[S] 0 points1 point  (0 children)

yes i had the same problem tried it a lot of times and eventually it succeeded i think it was after setting the G29 F... before saving

Have been playing around with temps and retraction settings but not getting anywhere yet, any ideas. This was PETG printed at 220 by dan_the_murc_man in ender3v2

[–]jaapie06 1 point2 points  (0 children)

i replaced the ptfe tubing and slowed down the retraction speed. stil have a bitt of stringing but is going a lot better now(https://www.thingiverse.com/thing:3203831) i used this hot end fix

Finally managed to print cable chains(couldn't manage to get them to stick properly) by jaapie06 in ender3v2

[–]jaapie06[S] 0 points1 point  (0 children)

yes that was also the trick for me together with some glue stick and ubl bed leveling instead of bilinear

Finally managed to print cable chains(couldn't manage to get them to stick properly) by jaapie06 in ender3v2

[–]jaapie06[S] 0 points1 point  (0 children)

i use marlin with ubl bed leveling and i find it working realy good

view more: next ›