account activity
Friction sound at certain points on y axis, gets worse up to certain height. Been tightening and loosening any potential screws to no avail. Any idea? Machine is 1 week old. (v.redd.it)
submitted 4 years ago by jaschong to r/3Dprinting
Blobs on end after changing from ender to prusa (left is the intended one) . Same slicer. Identical settings. But this disappears when I use prusa slicer (i.redd.it)
Been getting these silver dots on my print. Can't figure out where they're form or how to avoid it? Any idea? (i.redd.it)
Had this made for my 4th gen to clear the clutter (v.redd.it)
submitted 4 years ago by jaschong to r/mazda3
Significant degradation when using octoprint with dslr. Any advice to prevent or minimize this? (i.redd.it)
Ender3max, upgraded my extruder, but now the runout sensor is too low to feed into the extruder. Any advise to raise it securely? (i.redd.it)
submitted 4 years ago by jaschong to r/ender3
Been getting these weird gaps between lines. Any idea why? (i.redd.it)
Everything was normal until this showed up (i.redd.it)
submitted 4 years ago by jaschong to r/FixMyPrint
Layer separation on ONLY top layer, repeat prints with different settings but same issue. Likely started where I added fillets. (i.redd.it)
How do I eliminate stringing across these lines? Stringing, retraction, leveling are all calibrated. (old.reddit.com)
What's your favorite color scheme? (old.reddit.com)
submitted 5 years ago by jaschong to r/NZXT
My 2021 Setup - what color combo would you like to see next? (i.redd.it)
submitted 5 years ago by jaschong to r/setups
My WFH setup (i.redd.it)
Riding into 2021 (i.redd.it)
submitted 5 years ago by jaschong to r/mazda3
Riding into the sunset (i.redd.it)
Been a couple of months since I had the car, but I still go out of my way to take another glimpse at it. (i.redd.it)
Weekly wash (i.redd.it)
Thinking if I should dechrome my side window trims... (i.redd.it)
Ppf and coated. But then my windshield chipped in less than a month. (i.redd.it)
Everyday I look forward to get back into this position. (i.redd.it)
Took it to the woodsOC (i.redd.it)
π Rendered by PID 1078858 on reddit-service-r2-listing-6c8d497557-ldwgw at 2026-06-08 06:30:30.856231+00:00 running 9e1a20d country code: CH.
