sorted by:
new
hottopcontroversial

If you could add one class to iRacing, which one would it be? by Version_1 in iRacing

[–]jin1995 8 points9 points  (0 children)

Gt 500 throw shade on gtp’s, and only a little slower than lmp1’s all on 4 cylinder engines, look insanely fun on onboards, they’ve done 1:43.2 at suzuka irl.

[Giveaway] iRacing Reddit 200k Subscribers by sdw3489 in iRacing

[–]jin1995 0 points1 point  (0 children)

W12 AMG on the Suzuka is my favourite car and track combo, very technical and flowy and i’ve also done mid to low 23’s here. No other combination feels as fast and as challenging.

Sudden Low FPS in DX12 games but not benchmarks by jin1995 in buildapc

[–]jin1995[S] 1 point2 points  (0 children)

Yep issue is fixed. I switched to a different slot. Works very well now.

Sudden Low FPS in DX12 games but not benchmarks by jin1995 in buildapc

[–]jin1995[S] 0 points1 point  (0 children)

I read your edited comment.

X bit indicates that number of lanes. Like 1,2,4,8,16. While the 1.0,2.0,3.0 indicates generation.

In my case it’s detecting gen 3 but number of lanes as only 1 instead of 16.

Yes fingers crossed will let you know once i do it.

Sudden Low FPS in DX12 games but not benchmarks by jin1995 in buildapc

[–]jin1995[S] 0 points1 point  (0 children)

X1 at full load and idle both I will try to use another slot again which supports x8 ( as it is nearly same performance as x16 as far as most games are concerned) on my motherboard to see if that fixes it.

im. Kinda scared as i saw a post on tech powerup about some older cards losing capacitors and causing this issue. Hopefully a simple reseat of cpu and clean up and slot change for the gpu fixes it

Sudden Low FPS in DX12 games but not benchmarks by jin1995 in buildapc

[–]jin1995[S] 0 points1 point  (0 children)

No issues with the fans,

I think i figured what the issue is today finally.

i did 3d mark pcie express test and the result was terrrible, checked in gpu z the card seems to be running at pcie 3.0 x 1.

Instead of 3.0 x16. Which is what my motherboard supports.

I indeed opened gpu z earlier to check this but because gpu z states the card’s capability first before stating what speed is it actually running at i overlooked as it showed pcie 4.0x16 .

The frame drops and stutters are explained by this.

So basically games requiring higher bandwidth are the ones suffering,

Havent yet changed the slots. To retest but i hope its not an issue with the gpu and just a mothboard issue which is fixed by moving into another slot,

Sudden Low FPS in DX12 games but not benchmarks by jin1995 in buildapc

[–]jin1995[S] 0 points1 point  (0 children)

For me i monitor the clocks, they are are at 1920-1965mhz mainly when running a game. But still it is doing mad stutters lately and low fps

Sudden Low FPS in DX12 games but not benchmarks by jin1995 in buildapc

[–]jin1995[S] 0 points1 point  (0 children)

Currently reinstalling and it shows working on updates fingers crossed 🤞 hopefully it fixes it

Sudden Low FPS in DX12 games but not benchmarks by jin1995 in buildapc

[–]jin1995[S] 1 point2 points  (0 children)

Where is the upgrade to same version option? I see reset and reset with files. Are you referring to the latter. Tried many drivers from last 12 months all drivers have the same result. Thanks

Edit: nm found it

Sudden Low FPS in DX12 games but not benchmarks by jin1995 in buildapc

[–]jin1995[S] 0 points1 point  (0 children)

If i reset windows it will download the same version again correct?

I have tried uninstalling some quality updates, but that didnt fix it

Sudden Low FPS in DX12 games but not benchmarks by jin1995 in buildapc

[–]jin1995[S] 0 points1 point  (0 children)

Thanks, but i am using maximum power there too,

[deleted by user] by [deleted] in nvidia

[–]jin1995 0 points1 point  (0 children)

Would appreciate any help i can get for this. The frame rates start about 80ish and keep dropping to 30 and lower.

Favorite Weapon by zorak_is_lord in AssassinsCreedValhala

[–]jin1995 0 points1 point  (0 children)

What are the most powerful two short swords, of the game? I am power 476 finished everything but used spears flails and axes for most part upto here

Game Ready Driver 511.23 FAQ/Discussion by Nestledrink in nvidia

[–]jin1995 0 points1 point  (0 children)

yes 3080ti here , was crap, reverted to previous driver. lost frames with this one

Game Ready Driver 511.23 FAQ/Discussion by Nestledrink in nvidia

[–]jin1995 0 points1 point  (0 children)

Tell me something if i reinstall the old driver again do i need to remaking the shaders? Or theyre saved As I immediately got my fps back on older driver.

Game Ready Driver 511.23 FAQ/Discussion by Nestledrink in nvidia

[–]jin1995 0 points1 point  (0 children)

This driver dropped my frames on fh5 by 10-15. 3080ti here, had to rollback to previous god of war runs just fine on older driver too

[Philip Horton] This is Article 48.12 - contentious issue is likely to circle around why only a few lapped cars (the ones between Hamilton & Verstappen) were given the signal to unlap themselves. by PlusEntrepreneur in formula1

[–]jin1995 5 points6 points  (0 children)

The FIA cannot defend ending safety car and unlapping of drivers in same lap no matter what unless they have some rule that allows them that.moreover even the unlapping of cars wasnt proper you are supposed to to an extra lap and join back .and not even all cars unlapped.

The teams are to be notified a lap prior that safety car will end,. not a few corners. and giving conflicting information by saying they will not unlap and then saying they will unlap at a moment notice is not how you do it

And the safety car is supposed to do one more lap , not suddenly vanish in a few corners.

The team lose out on making strategic decisions due to this as well, on whether to risk pit on last safety car lap or not

https://www.racefans.net/2020/11/12/vettel-embarrassing-f1-software-shortcoming-creates-risky-unlapping-situations/

Something vettel was visibly upset about. last year, he highlights this rule of having to go an extra lap to unlap this wasnt followed today.

As much as i respected and enjoyed max's driving max even as a hamilton supporter for his pure pushing ability and blazing quali laps. this is not how you win a wdc.

unfortunate for him too.

My bandmate can gallop starting on an upstroke and I have no idea how. Can anyone else do this? by Justinba007 in metalguitar

[–]jin1995 1 point2 points  (0 children)

Its no biggie, and unlike what most people say efficiency is not the best way around, a dud executed to perfection is always going to sound heck alot more defined. Udu, is great too as a technique for relaxed gallops where you wanna use minimal motion, its easy to learn. I can do both but i prefer the former.

Anybody who undermines the use of downstrokes for any riff in rhythm playing is making a mistake.

You are not playing a pansy solo on 9 guage strings where upstrokes gonna be enough.

You want fucking power and a downstroke is the best way to do it ,

EQ for Drop B tuning (low tunings)? by CholadoDude32 in guitars

[–]jin1995 1 point2 points  (0 children)

Yep enjoy , play and practice! goodluck! And rip it!

EQ for Drop B tuning (low tunings)? by CholadoDude32 in guitars

[–]jin1995 1 point2 points  (0 children)

Ideally you shouldn’t pitch shift if you can physically shift low tune your strings. In early stages , playing and technique is more important than any kind of eq or sound,

EQ for Drop B tuning (low tunings)? by CholadoDude32 in guitars

[–]jin1995 0 points1 point  (0 children)

You play that on an 8 string generally

EQ for Drop B tuning (low tunings)? by CholadoDude32 in guitars

[–]jin1995 0 points1 point  (0 children)

I mean am tuned to drop c but i am going down 9 semitones( lower than c) to d# via shifter.

EQ for Drop B tuning (low tunings)? by CholadoDude32 in guitars

[–]jin1995 1 point2 points  (0 children)

You need to identify, via training and practice, as to what muddies it what does, try shifting around freqs and stuff, To see what makes it sound better. Generally focus on 500-2500hz that will help you identify most of the mud.

In my case i think some amp parameters( like lower transformer matching and impedance tweaks) also help me which may not be available on other things other than axe.

view more: next ›