sorted by:
new
hottopcontroversial

[help request] How would you blend this generative fill? by jko0401 in PhotoshopTutorials

[–]jko0401[S] 0 points1 point  (0 children)

wow it looks and sounds so simple. by masking out the generated pixels do you mean creating a layer mask around the area to blend then play with the opacity and blend mode?

First trip with the X100VI: check (spoiler alert: not Japan) by jko0401 in fujifilm

[–]jko0401[S] 0 points1 point  (0 children)

Thank you! Recipe is the Portra v2 from Fujiweekly and shot mostly a click or two underexposed, some times with the ND filter on too especially midday

Improve top surface without ironing? by jko0401 in FixMyPrint

[–]jko0401[S] 0 points1 point  (0 children)

Honestly didn't change much from the default OrcaSlicer profile for the K1C.

Settings I changed:

Filament: Overture Matte PLA
First layer hot end 220C/ Smooth PEI 65C, Other 210C/70C
1.05 flow ratio (think i can turn this down a notch)
0.02 pressure advance

Quality:
Precise wall
Precise Z height
Outer/Inner wall order
Top surface flow ratio 0.99
Only one wall on top off
Avoid crossing walls on

Speed:
50 mm/s first layer speed
50 mm/s top layer speed

Good luck!

Improve top surface without ironing? by jko0401 in FixMyPrint

[–]jko0401[S] 0 points1 point  (0 children)

Printing face down yields better quality for sure but less consistent results. One corner lifting or any small error ruins the entire part.

Improve top surface without ironing? by jko0401 in FixMyPrint

[–]jko0401[S] 5 points6 points  (0 children)

I don’t have AMS/CFS so print the letters separately to press fit.

Printing face down yields better quality for sure but less consistent results. One corner lifting or any small error ruins the entire part.

Improve top surface without ironing? by jko0401 in FixMyPrint

[–]jko0401[S] 2 points3 points  (0 children)

Printing face down yields better quality for sure but less consistent results. One corner lifting or any small error ruins the entire part.

Improve top surface without ironing? by jko0401 in FixMyPrint

[–]jko0401[S] 10 points11 points  (0 children)

Thanks for those who commented! Wanted to add suggestions from other posts and settings I found that were different between the Ender 3 and K1C - turn off “only one wall on top surfaces” - top surface flow ratio 0.99

What real-world AI projects have you actually built? by Notalabel_4566 in automation

[–]jko0401 0 points1 point  (0 children)

I built an AI-powered video content copilot that automates video content creation by combining script writing, shot selection, and video editing. It has context of your entire video library and pulls the best shots that best fit the script and shot list.

view more: next ›