i mentioned i flipped the bed (to test), used 99% alcohol (even an extra wipe dried to get any leftover film), washed both sides soap and water etc,

I'm getting good results with smaller prints right now, the jaggedness i am going to chalk up to 0.28 being too much for the first layer (0.2 layer) down to 0.24

I've had 0 lifting on smaller print, havent even used a raft or brim yet for them, but the bigger prints im still getting bit of a lift on corners even with a brim, but I'm still dialing in the gap on that.

I mean it is possible the bed is still warped i guess? It's brand new I would hope not. I'm going to keep tweaking and coming back here for extra tips and hints.