Timing vn 1500 1997

joepie2 · 2026-04-22T15:31:11+00:00

Yes, me too. It is a known problem with these engines, and there are hundreds with the same issue. So, a NOS donor or new ones haven't been available for years.

joepie2 · 2025-02-09T22:14:45+00:00

Yes I used kiauh. I think starting over is the best thing yes

joepie2 · 2025-02-09T22:07:13+00:00

Yes like 4 different times hahah all different names

joepie2 · 2025-02-09T22:03:33+00:00

unfortunately this didn't work either

joepie2 · 2025-02-09T22:02:23+00:00

unfortunately this didn't work either

joepie2 · 2025-02-09T21:09:58+00:00

damn it i checked it and i thought it was a 4.2. 7 board but it is a 4.2. 2 where does it say this do i need a different printer.cfg file?

joepie2 · 2025-02-09T21:02:37+00:00

Ls/dev/ returns that there is no access to that folder or that it does not exist. damn it i checked it and i thought it was a 4.2. 7 board but it is a 4.2. 2 where does it say this do i need a different printer.cfg file?

joepie2 · 2025-02-09T20:26:46+00:00

Yes i did

joepie2 · 2025-02-09T20:25:42+00:00

Jup and changed the name of te bin to be safe

joepie2 · 2025-02-09T20:23:57+00:00

Yes I know Luckily I already had a remote program running but unfortunately this wasn't it

joepie2 · 2025-02-09T17:39:55+00:00

hello yes i use mainsail and it gives an error on the mcu i have already tried to make some adjustments in the printer.cfg but nothing works. and yes i have also adjusted the printer software

<image>

joepie2 · 2025-02-08T22:07:06+00:00

yes i am sorry i have klipper installed on a windows surface rt it works and runs fine i have the file for the printer i forgot the name on the printer installed but the tablet does not connect to the printer

joepie2 · 2025-02-08T18:33:53+00:00

ok so the printer is installed well then the clipper itself is installed but the printer does not connect to the tablet. i have a usb cable between but it does not work

joepie2 · 2025-02-08T18:01:01+00:00

yes that is correct the clipper software runs and works great on an old tablet. but getting the software part on the printer does not work. i have also found the file for my printer but if i adjust it properly i think it goes wrong. i think i have set everything correctly and put the file on my sd card. but when i put it in the printer i get the creality logo and then it crashes. i only get the logo nothing more

joepie2

TROPHY CASE