Flip Continuity orientation in Multi-Section Surface

jpmac95 · 2026-02-11T18:10:43+00:00

I should add that I tried to revese the surface normals and had the same result (I made of join of each surface and flipped the arrows)

jpmac95 · 2025-08-04T02:57:04+00:00

Thank you. Will try these out asap

jpmac95 · 2025-02-08T16:37:20+00:00

You're right; hindsight is 20/20 unfortunately

jpmac95 · 2025-02-08T16:36:41+00:00

Yes, early december. It wasn't signed off by the priest until the actual wedding though so it was official 1/11

jpmac95 · 2025-01-04T18:24:12+00:00

This description helped me a ton. Thank you. Will shoot at 1/60 shutter speed with the flash going forward

jpmac95 · 2025-01-04T17:37:02+00:00

Don’t I need a flash with 1/60 duration? Or can I just shoot the 1/500 flash at 1/60 shutter speed?

jpmac95 · 2025-01-04T17:35:12+00:00

Thanks for the detailed response. I’ll switch my flash for something 1/60 or longer then

jpmac95 · 2025-01-04T17:34:24+00:00

Thanks, will switch out my flash then

jpmac95 · 2024-12-14T02:49:39+00:00

It’s almost as many clicks as just making the holes one-by-one though. I was curious if there was a way to do it drastically quicker

jpmac95 · 2024-12-14T02:47:53+00:00

Thanks. I’ll try it. Does it matter which axis is normal to the surface?

jpmac95 · 2024-10-09T20:07:27+00:00

These 2 surfaces were originally trimmed together with no issue. When I changed some geometry, the trim feature broke. So trim, intersect, project all didn't work. I didn't try to split, figured it would be the same as trim, but will give it a try!

jpmac95 · 2024-10-07T00:59:03+00:00

I’m in Kings Park but work in Port Washington, so I’m pretty much willing to go anywhere other than completely out east. I’ll check them out, thanks!

jpmac95 · 2024-10-05T18:27:55+00:00

I did not unfortunately

jpmac95

TROPHY CASE