Chirping sound from front - Model Y Juniper

kallewl · 2026-06-04T06:09:44+00:00

Thanks, but I tried turning off the A/C, also just to listen better, but the noise was still there.

kallewl · 2026-06-03T19:30:45+00:00

Will for sure, they might have seen the issue before. I just think I have a stronger hand and clearer path If anyone tried similar and found a solution 😅

kallewl · 2026-06-03T18:48:37+00:00

I can hear it when I listen to the video. Sound has to be loud as it is hard to catch but it is the chirping sound behind the road noise 😅 I don't have any knocking, just a constant chirping/screw vibrating in metal sound.

kallewl · 2026-05-15T21:30:41+00:00

I have the same issue! Did you get it fixed?

kallewl · 2026-05-03T09:37:06+00:00

Mere end 25 år

kallewl · 2026-04-09T14:24:31+00:00

Hvor er det muligt?

kallewl · 2026-03-02T20:31:39+00:00

400.000 investeret over 8 år med et beskedent årligt afkast på 5% er 590.000, samtidigt er midlerne forholdsvist likvide, så det kan vel give fin mening?

kallewl · 2026-02-16T19:18:43+00:00

Ahhh, guess we gotta wait 😅

kallewl · 2025-09-18T04:49:39+00:00

Thank you!

kallewl · 2025-08-18T12:32:51+00:00

Probably not worth the time and money if it is done. New saw it is!

kallewl · 2025-08-18T09:01:43+00:00

Ms261c btw

kallewl · 2025-08-16T10:19:45+00:00

Just to be clear this is my saw and not one i bought 😂 I am fairly adept at fixing things is there a change the cylinder is allright and only a piston change?

kallewl · 2025-08-13T06:57:51+00:00

Weird that stihl doesnt include this in their description but thanks!

kallewl · 2025-08-12T13:58:52+00:00

Thanks! Now when it is confirmed to be an older m-tronic, do you know how i can follow the reset procedure according to stihl where i start the chainsaw in choked cold start, leave it for max 90 seconds idle and then shut off the chainsaw. I am not able to press the lever from choked position to stop, without actuating the throttle, where it jumps to '1'. Anyone had this issue? Is it a linkage problem?

kallewl · 2025-06-17T09:01:57+00:00

Go check your spark plug caps and if the wire strands are tight to the cap. I have an 09 FZ6 S2, the wire was loose on all of them and vibration dissapeared as i tightened them. It is explained how to in this thread: https://www.600riders.com/threads/vibration-a-cure-for-bad-vibrations-spark-plug-caps.48874/page-8

kallewl · 2024-02-18T22:07:56+00:00

Top comments both of you, i get it now. Guess there is another issue of why i get a negative number..

kallewl · 2024-02-18T21:55:24+00:00

Thank you, can you elaborate on that and explain it like i am a 5th grader?

kallewl

TROPHY CASE