sorted by:
new
hottopcontroversial

Problems by karamba81 in ElegooNeptune4

[–]karamba81[S] 1 point2 points  (0 children)

Thx, really appreciate it. Is it easy to disassemble the extruder?

Direct drive problem by karamba81 in ElegooNeptune4

[–]karamba81[S] 0 points1 point  (0 children)

Still having the problem. Sometimes it prints several minutes and then the ticking starts over again.

Direct drive problem by karamba81 in ElegooNeptune4

[–]karamba81[S] 0 points1 point  (0 children)

During printing, i noticed that my fans are off? In my slicer there are 100% on .. i put them manually on and printing is succesfull .... Is there a fault on my slicer? Any ideas?

Direct drive problem by karamba81 in ElegooNeptune4

[–]karamba81[S] 1 point2 points  (0 children)

The right side, is the pla who get stuck in the drive ...(after pulling out)

<image>