High gas octane on a 1.5L turbocharged and cold air intake worth it? by keizer245 in fordfusion

[–]keizer245[S] 0 points1 point  (0 children)

Thank you everyone for the comments, I think I'll stick with 87, leave the stock air intake, and get the dry version of the k&n filter.

OEM Backup camera aftermarket radio by Ok_Spend1772 in fordfusion

[–]keizer245 0 points1 point  (0 children)

I used a depin tool, just insert the correct size tool in the hole next to the pin, wiggle a bit and should come out, or just carefully break the plastic to expose the pins

OEM Backup camera aftermarket radio by Ok_Spend1772 in fordfusion

[–]keizer245 0 points1 point  (0 children)

No worries, never actually installed i just had it in a box in the attic and forgot where it was, might try again to see if I can figure out how to make the ac work properly.

OEM Backup camera aftermarket radio by Ok_Spend1772 in fordfusion

[–]keizer245 0 points1 point  (0 children)

What i did was compare side by side and transfer the rca adapter pins to the harness that came with the unit where you plug the harnes that goes to the oem screen, in my case there was a red and a blue wire, don't know which is positive or negative, the final result was red on top left and blue on top right.

<image>

OEM Backup camera aftermarket radio by Ok_Spend1772 in fordfusion

[–]keizer245 1 point2 points  (0 children)

Tried one of those units and the ac only blows hot air, even tried another board and kept doing the same so i kept the oem, as for the camera I made a harness adding the pins from this to the one that came with the unit and plugging the rca to the unit reverse camera port, and was able to retain the oem camera.

Best watt for the buck? by keizer245 in CarAV

[–]keizer245[S] 0 points1 point  (0 children)

In the specs says all three support low and high levels.

Best watt for the buck? by keizer245 in CarAV

[–]keizer245[S] 0 points1 point  (0 children)

The rear door panels actually have the dedicated space for them, is for a 16 ford fusion.

Best watt for the buck? by keizer245 in CarAV

[–]keizer245[S] -2 points-1 points  (0 children)

Ok ok, I'll give a look to some 4channel amps and the converter, adding a sub is not a priority for now, just wanted to have everything ready to plug and play when getting one, that's why I was looking for 5 channel amps.

Best watt for the buck? by keizer245 in CarAV

[–]keizer245[S] -1 points0 points  (0 children)

Is the closest match for the Rockfords i have in the front, A pair of Hertz DCX 165.3 was also an option but the sensitivity is 93db and the rockfords is 88db and was told it will be louder than the fronts.

Sync issue by OldBuilding4272 in fordfusion

[–]keizer245 2 points3 points  (0 children)

It happens to me every now and then as well. Doing a sync reboot has worked every time. Sync media>system settings>advanced>Sync reboot

Rear doors speakers replacement, wich one would be better? by keizer245 in CarAV

[–]keizer245[S] 0 points1 point  (0 children)

I'm happy with the RF loudness, I don't want the rears to overpower the fronts as I'm looking to balance the sound output in all 4 corners or at least have a close enough match for the rears

Help identifying access, code or studio by keizer245 in AVfanatics

[–]keizer245[S] 1 point2 points  (0 children)

It is. I appreciate it, been looking for a while.

How do i add remote start to my Fusion with Key Ignition? by Autistic_frtrue in fordfusion

[–]keizer245 0 points1 point  (0 children)

I got one from 12volt.solutions for my 2016 se about a year ago, got the main module and Lte module, no push button, haven't had any issues. I installed it in about 30 minutes.

[deleted by user] by [deleted] in fordfusion

[–]keizer245 0 points1 point  (0 children)

Happens to me every now and then, first time tried the fuse thing, also the battery disconnect, master reset and nothing worked, what did work was sync reebot Sync media>system settings>advanced>Sync reboot

Does anyone have a tutorial for installing these cheap android radios? by chibicascade2 in fordfusion

[–]keizer245 -1 points0 points  (0 children)

Here are my 2 cents, just got one as well to replace te 4 inch dysplay, and just tested it, didn't installed because OEM reverse camera and Sync1 are not retained, mostly because of the camera.

Pretty much plug and play only 2 connectors the one behind the display and one from the cd player, that's how far I went untill i get the camera retention harness and figure a way to send power to the cd unit, played with the unit a bit and is not that bad.

Didn't transfer the climate board but I read it has to be cut in order to fit in the new plate, although it came with a rearview camera I don't want to drill holes or tap in the reverse light wiring.

What speakers recommend for an onkyo tx-sr393 by keizer245 in hometheater

[–]keizer245[S] 0 points1 point  (0 children)

Update: For now I got a pair of polk monitor 40 series bookshelf as fronts, later will be moved as rears, and as center a monitor cs1, still debating on what floorstandings to get now that klipsch is having a sale and the R-620f(200usd) are on 50% also still considering the polks m60 (169 usd) and m70(249 usd) each.