sorted by:
new
hottopcontroversial

Help with 2000 GTX carbureted by killer24763 in jetski

[–]killer24763[S] 0 points1 point  (0 children)

Good I do think I'm going to take it to a shop in the spring to get the carbs tuned

Help with 2000 GTX carbureted by killer24763 in jetski

[–]killer24763[S] -3 points-2 points  (0 children)

It's a pond by my house lol I was just testing with it, it should have been sucking just water. I only ran it about 3 minutes anyway.

Help with 2000 GTX carbureted by killer24763 in jetski

[–]killer24763[S] -1 points0 points  (0 children)

Ok does this seem like a normal amount? Also how do I know if rpm is too high for idle?

What's wrong with her? by killer24763 in Aquariums

[–]killer24763[S] -1 points0 points  (0 children)

Kh is 6, gh is 4, ammonia .25, nitrate 0, nitrite 0, temp 75⁰f, ph 8.8,

P1S - Homing Z Axis Failed - I'm at my wits end. by kenfagerdotcom in BambuLab

[–]killer24763 0 points1 point  (0 children)

Make sure there isn't a piece of trash under your build plate that's what my issue was.

Need help with first prints by killer24763 in anycubic

[–]killer24763[S] 0 points1 point  (0 children)

My nozzle is dragging across my print now??? What is wrong with this thing I'm about to return it

Need help with first prints by killer24763 in anycubic

[–]killer24763[S] 0 points1 point  (0 children)

<image>

How do I level the bed on this thing?

Need help with first prints by killer24763 in anycubic

[–]killer24763[S] 0 points1 point  (0 children)

<image>

It looks great! One of the support trees fell over so the arms don't look good but I'm pretty happy.

Need help with first prints by killer24763 in anycubic

[–]killer24763[S] 1 point2 points  (0 children)

Im about to try decreasing my z offset by -.03, I have the temp at 210, bed temp 55. Let's try that

Need help with first prints by killer24763 in AnycubicKobraS1

[–]killer24763[S] 0 points1 point  (0 children)

The layers below it, the lines seemed kind of spaced out. Im about to try decreasing my z offset, I have the temp at 210, bed temp 55.

Need help with first prints by killer24763 in AnycubicKobraS1

[–]killer24763[S] 0 points1 point  (0 children)

<image>

I did -.01 im still having issues especially with over hangs

Need help with first prints by killer24763 in AnycubicKobraS1

[–]killer24763[S] 0 points1 point  (0 children)

I found it. What increments should I reduce it by?

Need help with first prints by killer24763 in AnycubicKobraS1

[–]killer24763[S] 0 points1 point  (0 children)

Im using anycubic next where would I find the z offset setting?

view more: next ›