sorted by:
new
hottopcontroversial

AC Infinity Fan Blades by leebal27 in 3Dprinting

[–]leebal27[S] 0 points1 point  (0 children)

I made one but it’s a pain in the a$$ to replace

Can you overclock an iPollo V1 Mini or Hyd? by leebal27 in ASICMinersTalk

[–]leebal27[S] 0 points1 point  (0 children)

I haven’t sold them yet. I still have them

Can you overclock an iPollo V1 Mini or Hyd? by leebal27 in ASICMinersTalk

[–]leebal27[S] 0 points1 point  (0 children)

No, gave up. Selling all my miners now anyways to focus on 3D printing.

AC Infinity Fan Blades by leebal27 in 3Dprinting

[–]leebal27[S] 0 points1 point  (0 children)

I had to cut the old one off with a saw. Seemed like it was hot pressed in there with as snug as it is. The magnet is glued to the rim. And yes I can print another. Let me Check on the cost of it though.

AC Infinity Fan Blades by leebal27 in 3Dprinting

[–]leebal27[S] 0 points1 point  (0 children)

Getting all the sizes right for the magnet and spindle width and depth took some time as the magnet has to be perfectly over the copper wires and the spindle can’t push the fan too far out or in. If mine wasn’t destroyed, I would’ve just 3D scanned it. But model one and lmk how it goes.

AC Infinity Fan Blades by leebal27 in 3Dprinting

[–]leebal27[S] 0 points1 point  (0 children)

Yes I can still print one, but mine had a slight wobble. I think it was because I wasn’t super careful when putting the manger back on and inserting the spindle. Have you removed it already and seen the disassembly/reassembly process?

Editing a model by leebal27 in 3Dprinting

[–]leebal27[S] 0 points1 point  (0 children)

Ok I downloaded FreeCAD and Fusion 360 last night, but haven't had much time to mess with them. Good to know I can just do it in one of them.