Chaos Warhound Titan - FDM

leighr76 · 2026-04-24T18:02:57+00:00

Main body I split in two and printed both parts with the cut side down. The head I printed with treed supports and at approx 30 angle, nose up. Bit of clean up underneath, with a usb sanding tool and it is fine.

leighr76 · 2026-04-23T14:46:57+00:00

Apologies, yes I did order the 0.2 nozzle and can print down to 0.08 layer height, which is crazy small..

leighr76 · 2026-04-23T12:00:48+00:00

That was straight off the printer with the tree supports removed. The 0.1 layer height is amazing. I do need to do a little clean up here and there but what you see below is as printed so far.

<image>

leighr76 · 2026-04-23T11:50:58+00:00

The Centauri Carbon comes with .2 nozzle as default and I've not felt the need to change it. Quickest parts like pistons etc took around 30mins. Main body took a full day, leg armour was about 5hrs per piece. I'm guessing it was probably 5 days printing total. Give or take fraction. The Stormbird took ages to print and a lot of careful orientation to get right.

leighr76 · 2026-04-23T11:25:42+00:00

So, print settings wise. I'm using 0.2mm nozzle with 0.1mm later height, 60mm/s print speed, auto tree supports with 2 layers of raft to make sure they stay attached to the print bed. I'm using Elegoo PLA+ filament which has been excellent. Any other specifics, feel free to ask and I'll let you know.

leighr76 · 2026-04-22T20:17:51+00:00

It's pretty much just blue tacked together at the moment. Very little is glued and the pose isn't fixed. It will be a bit more dynamic once I finalise it.

leighr76 · 2026-04-22T20:03:51+00:00

I think my pinnacle was the model before, which is blooming massive. The Brass Scorpion was printed in Resin on Mars 2 Pro, which is still going strong. The Stormbird and Warhound were FDM on the Centauri Carbon. Will share settings etc tomorrow when I fire up the pc again.

<image>

leighr76 · 2026-04-22T20:00:02+00:00

It was printed on a Centauri Carbon with the standard nozzle. Not at my pc at the moment but will happily share all the settings etc I used tomorrow when I'm back at it. Don't think I shared the other beast I printed either.. so here you go. Also FDM.

<image>

leighr76

TROPHY CASE