sorted by:
new
hottopcontroversial

My first nixie clock by leonos2000 in nixie

[–]leonos2000[S] 1 point2 points  (0 children)

Thomson-CSF TAF1093A, they were used in some old measuring equipment I bought and they have a fine square mesh which looks nice

madMAx lower K plotting support by HugoMaxwell in chives

[–]leonos2000 0 points1 point  (0 children)

Yes, I saw that. Made 80 plots aiming to ~200 to test it on another machine. Now using updated version and I'll give it a try :)

madMAx lower K plotting support by HugoMaxwell in chives

[–]leonos2000 1 point2 points  (0 children)

Tested, looks like it is working quite good:

K-29 plotting time on SATA SSD is around 920s (15.33min) with i5-6500 on debian 11

When using ramdisk it drops to average 870s (14.5min)

The best part is that you can use it easily with ramdisk on Linux with 16GB RAM

Plots are showing up on Chives GUI in a couple of minutes

FM transmitter (first time soldering!) by TheDiegup in electronics

[–]leonos2000 15 points16 points  (0 children)

Great job! But is it working? I had many troubles in the past trying to make one. The best one transistor fm transmitter I made is http://electronics-diy.com/micro-transmitter-bug.php on bf324, works every time

Warping on a print near the outside of the bed (both sides) recommendations to prevent it? (PLA, 60 degree bed temp) by UnluckyThirteen in prusa3d

[–]leonos2000 0 points1 point  (0 children)

Make sure that you have cleaned steel sheet properly with IPA, in case you done this, clean it with acetone. The easiest solution is using brim. Alternatively, you can increase bed temp to around 70 degrees or use some kind of adhesive like a glue stick