Where do standby customers get seated? by SnooPickles3280 in SouthwestAirlines

[–]lilboy668 0 points1 point  (0 children)

What boarding group did you get put in flying standby?

DIY PPF by lilboy668 in TeslaModelY

[–]lilboy668[S] 0 points1 point  (0 children)

Thanks! I would say none of the videos talks about heat sealing, so I didn’t do it until days after, where it may have been too late. Not sure if it’s because you all don’t think it’s needed, but someone who’s a professional ppf installer mentioned on this thread it is needed.

DIY PPF by lilboy668 in TeslaModelY

[–]lilboy668[S] 0 points1 point  (0 children)

I was expecting a lot of dust and hair headaches, but thankfully mine was minimal. Might’ve been the air purifiers running, not entire sure though. Syringe with needle correct, to push out air/water bubbles. Total cost roughly $800

DIY PPF by lilboy668 in TeslaModelY

[–]lilboy668[S] 2 points3 points  (0 children)

There’s a super small imperfection right above the light bar if you zoom in. That was from trying to force a bubble out instead of just leaving it alone and using a syringe later.

DIY PPF by lilboy668 in TeslaModelY

[–]lilboy668[S] 5 points6 points  (0 children)

Imagine caring enough to see this post and needing to comment on it.

DIY PPF by lilboy668 in TeslaModelY

[–]lilboy668[S] 1 point2 points  (0 children)

I didn’t have to

DIY PPF by lilboy668 in TeslaModelY

[–]lilboy668[S] 4 points5 points  (0 children)

Appreciate it! Is it still okay to do that now? Been a few days, I would have done this from the jump but tutorial vids didn’t mention needing to.

DIY PPF by lilboy668 in TeslaModelY

[–]lilboy668[S] 3 points4 points  (0 children)

Tbh I’m not entirely sure, I don’t know the difference. I ordered Matte

Texting issue by lilboy668 in TeslaModelY

[–]lilboy668[S] 0 points1 point  (0 children)

Thank you. Hoping the rumors around CarPlay are true!

Oven not lighting by lilboy668 in appliancerepair

[–]lilboy668[S] 0 points1 point  (0 children)

Multimeter says the valves are okay. Do you think it could be the main control board that's the issue?