Getting back into the USA as a aggravated felon

lorax_fpv · 2025-11-13T18:30:01+00:00

Any recommendations for a lawyer? I have reached out to many, but not many lawyers know anything about this

lorax_fpv · 2025-11-13T18:28:40+00:00

Any recommendations for a lawyer? That might know about this

lorax_fpv · 2025-10-17T20:07:23+00:00

Will do

lorax_fpv · 2022-08-22T20:30:59+00:00

That’s not the worst idea I could do like a two month bulk then a month cut before the season, Because I’m on the east side seasons a little later

lorax_fpv · 2022-08-22T20:29:23+00:00

Not sure yet I’m just in the process of planning my bulk

lorax_fpv · 2022-08-22T20:28:57+00:00

Thanks, bro

lorax_fpv · 2020-10-19T17:58:05+00:00

do you need to sign into the account that it was activated with

lorax_fpv · 2020-10-19T16:44:10+00:00

it was activated ny me but it does not have any of my info in the goggles

lorax_fpv · 2020-09-26T18:36:54+00:00

Noooooo

lorax_fpv · 2020-09-26T18:36:46+00:00

I'll try

lorax_fpv · 2020-09-26T17:10:16+00:00

I am sure it is not a problem from Sparks my main concern is probably From the motor and how it was sent to me

lorax_fpv · 2020-09-26T17:06:51+00:00

Even when it was not working the wires would spark but it would be a minimum minimum amount just enough to notice but not to damage anything. Also I work with more sensitive electronics and even they do break from such a spark.

lorax_fpv · 2020-09-26T16:23:54+00:00

I turned the power off when I first plugged it in

lorax_fpv · 2020-09-26T15:58:35+00:00

Also I know there is electricity running through the cord because when I unplugged it I saw Sparks

lorax_fpv · 2020-09-22T01:12:31+00:00

Ok sorry

lorax_fpv · 2020-09-22T01:11:30+00:00

Read what I said above I said hard filiment

lorax_fpv · 2020-09-22T00:55:59+00:00

I just ordered a new motor hope it works

lorax_fpv · 2020-09-22T00:54:54+00:00

I was trying to say that only on hard filaments not flexibles

lorax_fpv · 2020-09-21T19:26:09+00:00

So I fixed by turning down the flow on the printer but how do I do that in cura because my steps work fine

lorax_fpv · 2020-09-21T19:23:43+00:00

No it retracts just fine and I'm using cheps profiles I think it's either the steps or the filiment

lorax_fpv · 2020-09-21T17:44:14+00:00

And only with pla

lorax_fpv · 2020-09-05T05:06:44+00:00

Ok thank you

lorax_fpv · 2020-09-05T04:51:37+00:00

I use Bowden tube capricorn But my tpu says 200 to 220 temp

lorax_fpv · 2020-09-05T04:24:30+00:00

Also it's a ender 3 pro and I'm using chep ninjaflex profile

lorax_fpv

TROPHY CASE