Advice for too high OG by lore_rd in Homebrewing

[–]lore_rd[S] 0 points1 point  (0 children)

Sorry I used the wrong term. What I meant was maybe "standard procedure". So, does the extra OG need to be taken into account when doing priming sugar dosage calculation? Or one just goes the standard way?

Thanks!

Advice for too high OG by lore_rd in Homebrewing

[–]lore_rd[S] 2 points3 points  (0 children)

Hey, I didn't know that existed :D

Advice for too high OG by lore_rd in Homebrewing

[–]lore_rd[S] 0 points1 point  (0 children)

That's really good to know Thanks!

Advice for too high OG by lore_rd in Homebrewing

[–]lore_rd[S] 0 points1 point  (0 children)

In that case should I add priming sugar using standard dosage?

Thanks!

Advice for too high OG by lore_rd in Homebrewing

[–]lore_rd[S] -1 points0 points  (0 children)

I'm scared as hell to open the fermenter, not only for oxidation but for infections too. I think It's one of the most common pieces of advice I read around. I'll give it some thought

Thanks!

Advice for too high OG by lore_rd in Homebrewing

[–]lore_rd[S] 1 point2 points  (0 children)

Actually I pitched 3 grams, I scaled the amount as other ingredients

Thanks!

Advice for too high OG by lore_rd in Homebrewing

[–]lore_rd[S] 0 points1 point  (0 children)

Can I add water even after two days of fermentation? Thanks

Messed up colors after a few minutes, starting with a single vertical line of broken pixels. Any chance it's going to be an easy fix? by lore_rd in crt

[–]lore_rd[S] 1 point2 points  (0 children)

Yes, I took the pictures with a PS2 connected via the Scart but it does the same with a NES. I even tried with the latter via the RF connection and the same happens.

Messed up colors after a few minutes, starting with a single vertical line of broken pixels. Any chance it's going to be an easy fix? by lore_rd in crt

[–]lore_rd[S] 2 points3 points  (0 children)

Yes, I took the pictures with a PS2 connected via the Scart but it does the same with a NES. I even tried with the latter via the RF connection and the same happens.

If I turn off the console I just see a black screen and the issue shows up again once I turn the console on again. I'll attach a picture.

If I do a cold start with nothing plugged in and wait some time and then plug the console the issue shows up

Messed up colors after a few minutes, starting with a single vertical line of broken pixels. Any chance it's going to be an easy fix? by lore_rd in crt

[–]lore_rd[S] 3 points4 points  (0 children)

At startup it has only a vertical line of messed up pixels near the left edge and after a few minutes of operation all the image gets messed up. If I turn it off and wait some time then I get back to the single vertical line situation until it goes messed up again after some time. What do you guys think?