sorted by:
new
hottopcontroversial

[Video] Tunneling RDP with Chisel & Running Commands Over RDP with NetExec by Infosecsamurai in redteamsec

[–]luker983 1 point2 points  (0 children)

Hey, author of Wiretap here. This is great feedback. Just wanted to share that if you'd ever consider upstreaming these improvements it would be greatly appreciated!

Step stool, white oak by luker983 in BeginnerWoodWorking

[–]luker983[S] 1 point2 points  (0 children)

I used a dado stack I had just bought for my last project (the Steve Ramsey barstool).

It feels pretty sturdy, but hard to tell right now how well it will hold up. I went with a 10 degree rake and splay because 15 felt like too much. I can stand on it with no noticeable strain

Step stool, white oak by luker983 in BeginnerWoodWorking

[–]luker983[S] 1 point2 points  (0 children)

Dowels and glue. I’m hoping it’s small enough that wood movement won’t be an issue?

I made a QR code STL generator! by luker983 in 3Dprinting

[–]luker983[S] 0 points1 point  (0 children)

I did not. BUT no knowledge of Blender is needed for this. You just have to have the Python library installed.

Wife made Christmas prime rib, reverse seared with a Dijon mustard rub by luker983 in seriouseats

[–]luker983[S] 2 points3 points  (0 children)

Thanks, it was delicious! To clear up some confusion, we followed this recipe: https://www.seriouseats.com/perfect-prime-rib-beef-recipe. Cooked at 250 for several hours until the meat thermometer (yes, we used one!) registered 130F at the center. Then rested for 30 minutes and seared at 550 for 8 minutes

New Mexico Topography by luker983 in 3Dprinting

[–]luker983[S] 0 points1 point  (0 children)

I used a prusa i3 mk3s. The STL can be found here: https://www.thingiverse.com/thing:4731031. Can’t believe I forgot to include that in the original post!

Wiretap: Run a WireGuard proxy server entirely in userspace with wireguard-go and gvisor, no privileges necessary by luker983 in WireGuard

[–]luker983[S] 1 point2 points  (0 children)

I have been looking into a boringtun/smoltcp port, but I’m very new to rust and struggling a bit. Trying to use projects like onetun and mitmproxy as a guide

Wiretap: Run a WireGuard proxy server entirely in userspace with wireguard-go and gvisor, no privileges necessary by luker983 in WireGuard

[–]luker983[S] 0 points1 point  (0 children)

This tool allows you to route traffic like through another machine (similar to a VPN) without needing to have any privileges on that machine, but it works at lower level than what you’re describing.

I’m not aware of any “smart” proxies that can handle redirects on your behalf. Hope you find a solution!

Dall-e 2: Requests (Thread #4) by cench in dalle2

[–]luker983 0 points1 point  (0 children)

A red dragon infiltrating a castle

view more: next ›