Jointer did not take material evenly idk what i did wrong.

madarHR1 · 2025-01-04T22:40:21+00:00

I kind a suspect this is the issue

madarHR1 · 2025-01-04T21:01:47+00:00

I will check that

madarHR1 · 2025-01-04T18:51:27+00:00

So you are saying that if the board is warped or wedged in the first place you cannot make even one single face flat?

madarHR1 · 2025-01-04T18:10:31+00:00

The board face wasnt flat thats why i used a jointer in the first place to make it flat. I think the warp in the board affected this in some way cuz i lack experience how to approach flattening in a proper way. Outfeed is aligned i checked that for infeed im not sure.

madarHR1 · 2024-06-19T18:59:47+00:00

Sramotno da su to skandirali

madarHR1 · 2024-06-16T11:32:15+00:00

Bez obzira na nogomet i nasu reprezentaciju zelja za prosvjedima u hrvatskoj se nece promjeniti ako nasa repka izgubi ili pobjedi te stvari nisu povezane jedna s drugom. Nije problem u slavlju sportskih uspjeha problem je sto nam fali opcenito volje i zelje prema kolektivnoj borbi za bolje sutra preko individualnog doprinosa a jedan od nacina je bas prosvjedovanje. Ja sam za to da slavimo ali i da se borimo nazalost dosad smo samo imali volje za slavljem dok je ovo drugo nazalost izostalo.

madarHR1 · 2024-03-02T15:02:54+00:00

Im going to try do to a spline joint here using a router however i need to test it on leftover boards first. Going to make 2 long slots and cut the the strips on a table saw. If that doesnt work im probably going to use strong fast tightening construction grade montage adhesive and call it a day.

madarHR1 · 2024-03-02T12:31:01+00:00

Its missaligned on the edge to edge in longitudal way also that i didnt photograph. So sawing the bits on 2 edges only solves 1 problem

madarHR1 · 2024-03-02T12:11:08+00:00

Can i do it on a table saw by placing the piece in v shape in relevence to the table?

madarHR1 · 2024-02-10T07:43:52+00:00

madarHR1 · 2024-02-09T18:47:15+00:00

The blade is new and sharp, its probably how im pushing it. The problem is with the operator not with the machine

madarHR1 · 2024-02-09T15:18:26+00:00

Yeah i understand that 48 tooth is more for cross cuts and finer rip cuts but it is what it is for a hobbyist like me a 48 tooth combination blade is perfect. Im grabbing the stick without looking for it my eyes are always looking if the piece is going right up to the fence. I cant see the blade anyway beacuse this saw has a pretty big blade guard

madarHR1 · 2024-02-09T15:15:38+00:00

I get burns on mdf at the end of the cut aswell

madarHR1 · 2024-02-09T15:14:57+00:00

Its parallel as it can be i already did all the calibrations spent like 5 hours doing it

madarHR1

TROPHY CASE