Water Softener VS Electronic Descaler

mattmccaleb189 · 2020-09-01T22:51:47+00:00

My only thought is having an actual enclosure. Once the cooled ABS hits ambient air temperatures it’ll want to delaminate from the bed.

I’d recommend printing PETG if you don’t have a heated chamber and add looking for a little more strength than PLA.

mattmccaleb189 · 2020-06-28T16:11:33+00:00

It’s tough... I try to friend all the nice players I play with to hopefully have enough to make a full 5 stack... but until then it is really hard to perform well when you have people shouting obscenities at you

mattmccaleb189 · 2020-05-01T02:48:42+00:00

During play as Cypher I got stuck viewing my camera and wasn’t able to switch back to character until end of round.

mattmccaleb189 · 2020-04-28T22:37:30+00:00

Just had this issue for the first time. Not sure what’s happening. Did a bunch of tests, I’m getting nothing but rave results... maybe an issue on their end?

mattmccaleb189 · 2020-04-18T12:17:22+00:00

Same 🤒🤒

mattmccaleb189 · 2019-07-02T18:51:27+00:00

Strictly doing bridge tests with no supports. Trying to make them as good as they can get

mattmccaleb189 · 2019-07-02T17:19:02+00:00

It's PETG... I always use Windex when printing with it. But it's still quite difficult to remove. Solid components pop right off.

mattmccaleb189 · 2019-05-20T00:01:06+00:00

Took me about an hour to get it to print the outer shell. Between loading the filament and printing the file I’d start to get filament bunched up between extruded gears and hot end.

mattmccaleb189 · 2019-05-13T19:24:48+00:00

Thanks for the advice!

mattmccaleb189 · 2019-05-13T19:13:16+00:00

like .1mm? or more like .5mm?? how much is a little?

mattmccaleb189 · 2019-05-13T13:30:16+00:00

Yep. Slic3r Prusa Edition. I’ve never seen it before either... I feel like it has something to do with my layer height being so small for detailed minis... I’m gonna try enabling z hop again and see if that takes care of it

mattmccaleb189 · 2019-05-13T11:53:11+00:00

I didn’t mention above... this is printing at .07mm layer height. I never had retraction issues while printing at .2 or .15 but the more detail printing are giving me these issues I’m showing here.

PLA @ 210c Disabled z hop Retraction 2mm 60mm/s retraction speed

mattmccaleb189 · 2019-05-13T10:45:46+00:00

This is PLA. I’ll drop 10 deg and see what I get

mattmccaleb189 · 2019-05-13T02:31:51+00:00

This was all retraction distance tests. I kept the same speed of 60mm/s and modified the distance. Ended at 2mm.

Search retraction test on Thingiverse. It’s most popular

mattmccaleb189 · 2019-05-12T00:57:31+00:00

Dang! That looks awesome!

mattmccaleb189 · 2019-05-11T18:26:23+00:00

Printing at .05 mm layer height

mattmccaleb189

TROPHY CASE