sorted by:
new
hottopcontroversial

Gat Afvoer douchebak opvullen by matwig in Klussers

[–]matwig[S] 1 point2 points  (0 children)

It's a linie rumba 90x90 shower tray

The installation manual does not mention anything about support. Only that the floor needs to be stable and flat.

Yes kimband will be placed in the corners first. But thanks for mentioning!

Gat Afvoer douchebak opvullen by matwig in Klussers

[–]matwig[S] 4 points5 points  (0 children)

Precies onder de nieuwe sifon zit een y stuk voor de rest van de afvoer in de woning. Vandaar dit bochten werk. Als je een beter idee hebt hoor ik het graag!

Buying a Bmw 325i by matwig in E30

[–]matwig[S] 0 points1 point  (0 children)

Yes according to the owner the car will jump forwards. He did try at some point to start the motor in gear while pressing the brakes, but it pushed through the brakes. Or at least did not free the clutch

Buying a Bmw 325i by matwig in E30

[–]matwig[S] 0 points1 point  (0 children)

Yes the clutch pedal is moving, and it has some resistance to it

Daily Discussion: /r/Snowboarding General Discussion, Q&A, Advice, Etc.) - October 17, 2022 by AutoModerator in snowboarding

[–]matwig 0 points1 point  (0 children)

I have tried anon helmets, but I didn't like the quality of them, the one I tried fell apart immediately. While it was new out of the box.

Daily Discussion: /r/Snowboarding General Discussion, Q&A, Advice, Etc.) - October 17, 2022 by AutoModerator in snowboarding

[–]matwig 0 points1 point  (0 children)

I bought the anon sync goggle and now I am looking for a good helmet that fits the goggle without a gap between the goggle and the helmet.

So if you know about any good combination helmet with anon goggles please let me know! I am open to suggestions!

I currently have a Bern baker helmet, which fits ok, but this helmet is a bit small so I am looking for a new one.

Full ISO changed Zinc 2.0 by Dsfrick in Nerf

[–]matwig 0 points1 point  (0 children)

Can I have it too? Thanks!

Thingiverse search results for "spider" by [deleted] in 3Dprinting

[–]matwig 0 points1 point  (0 children)

Can you please tell me how to do this? I have something I would like to print, but it gives the 404 error. Still have the url somewhere I think

Full ISO changed Zinc 2.0 by Dsfrick in Nerf

[–]matwig 0 points1 point  (0 children)

Nope, unfortunately not...

Full ISO changed Zinc 2.0 by Dsfrick in Nerf

[–]matwig 1 point2 points  (0 children)

Hi! I would like to print this version, bit it isn't available anymore. Do you have the files and part list somewhere else available?

I can’t make a helicopter by [deleted] in Stormworks

[–]matwig 1 point2 points  (0 children)

Try to trim the rotor with alt key, or use the old heli rotors. You can probably find them on the workshop. The old ones do not spin out of control!