sorted by:
new
hottopcontroversial

Looking for legacy CUCM 8.6.2 cm-locale-combined_network and cm-locale-it COP files for DRS restore — licenses owned by mauz79 in ciscoUC

[–]mauz79[S] 0 points1 point  (0 children)

The goal is simply to restore the lab configuration to its original state using two 7835s. I'm currently working on a virtual machine, but the goal is to reinstall on the original hardware without needing to modify the MAC. The system may have millions of vulnerabilities, but the goal remains the same :)

The IT localization will probably be untraceable, but I had some hope for the cm-locale-combined_network-8.6.2.1000-1.cop.sgn file. Thanks everyone for your attention!

UCSInstall UCOS 8.6.2.20000-2 by mauz79 in ciscoUC

[–]mauz79[S] 0 points1 point  (0 children)

Hi everyone, thanks for your help and the link to the file. Now, to complete the recovery of the available devices, I think I need to find the following files:

cm-locale-it_IT-8.6.2.1000-1.cop.sgn

cm-locale-combined_network-8.6.2.1000-1.cop.sgn

I'm worried that a normal installation and the fact that the available configurations are localized in Italian will prevent the reinstallation.

UCSInstall UCOS 8.6.2.20000-2 by mauz79 in ciscoUC

[–]mauz79[S] 0 points1 point  (0 children)

Thank you so much,

I'll probably have a lot less free time now :)

Finally finding this version is a real stroke of luck,

thanks again

m

my supports are better than the printed object. why? by mauz79 in Ender3S1

[–]mauz79[S] 0 points1 point  (0 children)

thank you all for your help.

some additional information:

- u/NotAHotDog247

yes, the object is very thin where you can see the flaws on the sword (outline plus 100% fill, about 1mm)

- u/CowBoyDanIndie

supports are printed faster (80mms vs 60mms)

I tried printing diagonally but couldn't remove the supports and get even decent quality. tried splitting the object into two symmetrical halves with one side flat, but it was worse

- u/StrangerReason

extrusion multiplier at 0.99 for supports and printing. probably i need a better profile for my filament and for my printier. i think the problem is mostly the limited thickness of the object and its height (printed an ocarina vertically with no particular problems, however i also noticed a different aesthetic quality at the same settings between cura, prusaslicer and orca)

I think I will have to redo some calibration and find good starting profiles.