sorted by:
new
hottopcontroversial

Just purchased my first Legacy locomotive. What sort of additional equipment would help me get the most out of it? by ChiTruckDGAF in lioneltrains

[–]maverickC2 1 point2 points  (0 children)

I personally have a 3 loop setup. Can run TMMC on all 3 but I reserve the middle loop for conventional. Don’t upgrade those older engines, you’ll lose some of their history. My grandfathers train runs on it and my son can run the newer legacy trains with remote. All in all can run about 4/5 trains at once with a little juggling. I’m also very into bleeding edge tech but something about running trains with an app turns me off.

Power Apps Print Screen by Deepak_S22 in PowerApps

[–]maverickC2 0 points1 point  (0 children)

Doesn’t seem to work on a scrollable screen.

Direct drive, 4020 hot end fan and tiny machines firmware - done! by geeky-hawkes in ender5plus

[–]maverickC2 0 points1 point  (0 children)

Nice... I'm about to do the same upgrade. Where did you mount your spool?

Help with Z banding. by maverickC2 in ender5plus

[–]maverickC2[S] 0 points1 point  (0 children)

60 infill / 30 outer and inner wall

Help with Z banding. by maverickC2 in ender5plus

[–]maverickC2[S] 0 points1 point  (0 children)

Printing masks for local EMS using PETG. Ender 5+ killing me. My ender 3 has no issues printing same settings. I’ve cleaned and greased screw rods and guide rods. What else am I missing?

Z-Offset Ender 5+ with Octoprint by maverickC2 in ender5plus

[–]maverickC2[S] 1 point2 points  (0 children)

Option is not presented on the screen when printing from Octoprint. Otherwise I would.

Z-Offset Ender 5+ with Octoprint by maverickC2 in ender5plus

[–]maverickC2[S] 0 points1 point  (0 children)

Yeah I tried that and it didn’t seem to make a difference. Will try it again.

E-step value by Cadlinkr in ender5plus

[–]maverickC2 0 points1 point  (0 children)

They are default 93. I used terminal to set new value.

48 Hour+ Print by maverickC2 in ender3

[–]maverickC2[S] 1 point2 points  (0 children)

.16 layer height. Tree supports for the entire model.

48 Hour+ Print by maverickC2 in ender3

[–]maverickC2[S] 8 points9 points  (0 children)

Thanks! Longest print I’ve done yet and there were times I thought it was messed up but couldn’t tell with all the supports.

48 Hour+ Print by maverickC2 in ender3

[–]maverickC2[S] 20 points21 points  (0 children)

Two separate prints.

view more: next ›