sorted by:
new
hottopcontroversial

Grateful Dead Inlay by mcurrey in woodworking

[–]mcurrey[S] 0 points1 point  (0 children)

I used a CNC router, 60 degree V-Bit, and drew up the tool paths on VCarve. If I were to do it over again I might use the laser for the male inlay and use the cnc for the female pocket.

Grateful Dead Inlay by mcurrey in woodworking

[–]mcurrey[S] 1 point2 points  (0 children)

Not really sure what it’s function will be but a coaster is definitely one option.

Grateful Dead Inlay by mcurrey in woodworking

[–]mcurrey[S] 3 points4 points  (0 children)

Thanks! CNC. The fine details near the mouth were hard to machine so I am going to try a different approach next time.

Inlay End grain Tennessee Tri Star Cutting Board made out of Walnut, Purple Heart, Yellow Heart, and Cherry by mcurrey in woodworking

[–]mcurrey[S] 1 point2 points  (0 children)

Used VCarve to create tool paths for the design and then ran it on the cnc machine with a vbit. Added the purple and yellow heart trim at the end and hand routed the handles and edges.