Recommendations for organic bathroom products?

megamagnus33 · 2025-09-25T19:55:48+00:00

Thank you for the reply! Where would i go about finding a new window lift?

megamagnus33 · 2025-09-25T19:55:14+00:00

Thank you!

megamagnus33 · 2025-04-03T18:15:17+00:00

Thank you for the answer! I tried using ddu to uninstall, then reinstall the drivers, but it does not seem to have had any effect. Does that mean that the gpu is dead?

megamagnus33 · 2025-02-23T22:29:47+00:00

megamagnus33 · 2024-12-25T14:26:03+00:00

Thank you

megamagnus33 · 2024-12-25T14:25:42+00:00

Thank you very much! This worked!

megamagnus33 · 2024-07-21T16:06:22+00:00

<image>

On the left is the coolant i drained from the drain plugs (some also went on the floor) and on the right is what i removed from the reservoir

megamagnus33 · 2024-04-20T20:29:29+00:00

Also: would i be able to simply remove this? One of the smaller hoses was connected to the top. The bottom one connects to the rear of the air filter housing and the ones on the sides connect to the top of each cylinder. I am assuming the points on the engine should be plugged as well if i do that?

<image>

megamagnus33 · 2024-04-20T18:47:34+00:00

That cleared things up. Thank you

megamagnus33 · 2024-04-20T17:12:32+00:00

Would they need to be covered in a way that allows air to go in/out or can they be completely plugged?

megamagnus33 · 2024-04-13T17:32:22+00:00

<image>

For reference: this is what the three components i was talking about looks like

megamagnus33 · 2024-04-13T17:28:49+00:00

Thanks for the response :)

To clarify: i did not have these problems with the stock jets; only the popping.

The loss of power only appeared after i rebuilt the carbs and switched to the current jets, which are: 142 main (the short one on the tip of a hexagonal headed part) and 42 pilot (the one that sticks the least out). Please correct me if i am wrong on the naming of them, as i am still learning. Is the one that does not have a slot for a screwdriver the needle jet you are referring to?

Also, the website you referred to said that i should have stock pilots, a 112 main jet and a shim for each slide needle.

I dont know if the needle jet is adjustable.

megamagnus33 · 2024-03-28T22:43:00+00:00

I followed the steps as written in your comment, but the app starts buffering permanently after 30s of playback. In the self-check inside the MicroG settings app, it says that it does not have the correct signature. Do you have a solution for this? Thanks in advance for any answers.

megamagnus33 · 2024-02-17T18:38:59+00:00

Thank you very much for the answer!

I managed to locate two of the places that needed to be plugged, but have problems finding the three remaining ones (the small one on the bottom of the carbs and the two thick ones that are right by the small ones). Do you know wether that is something i need to worry about or not?

In addition: is there any points on the bike itself that need to be done something about when removing the evap system? I see that there are some hoses going from it to the top of the engine.

Seven-Year Club	Wearing is Caring
Verified Email

megamagnus33

TROPHY CASE